Garmin GMR Fantom 56 Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schiffsausrüstung Garmin GMR Fantom 56 herunter. Garmin GMR Fantom 56 12 Seiten.
Auch für Garmin GMR Fantom 56: Installationsanleitung Handbuch (19 seiten)
Seite drucken
2
Go to www.garmin.com/express.
3
Follow the on-screen instructions.
Viewing Regulatory and Compliance
Information
From the system settings, select Regulatory.
Resetting the Device
You can reset your device if it stops functioning.
Hold the power key for 12 seconds.
Specifications
Operating temperature range
Charging temperature range
Input voltage
Wireless frequencies
Appendix
Changing the Fuse in the Vehicle Power
Cable
When replacing the fuse, do not lose any of the small pieces
and make sure they are put back in the proper position. The
vehicle power cable does not work unless it is assembled
correctly.
If your device does not charge in your vehicle, you may need to
replace the fuse located at the tip of the vehicle adapter.
1
Rotate the end piece
TIP: You may need to use a coin to remove the end piece.
2
Remove the end piece, the silver tip
3
Insert a new fast-blow fuse that has the same current, such
as 1 A or 2 A.
4
Place the silver tip in the end piece.
5
Push in the end piece and rotate it clockwise to lock it back
into the vehicle power cable
Recording Videos While Parked
Due to privacy regulations, this feature is not available in all
areas. It is your responsibility to know and comply with
applicable laws and rights to privacy in your jurisdiction.
Before you can record videos while parked, you must connect
your camera to the Dash Cam parking mode cable accessory
(Parking Mode Cable Wiring Diagram, page
The parked video recording feature allows the camera to record
video automatically while your vehicle is parked.
Select
> Settings > Camera > Record While Parked.
When you turn off your vehicle, the camera enters parked
recording mode and automatically records video each time the
camera sensor detects motion.
6
From -20° to 45°C (from -4° to 113°F)
From 0° to 45°C (from 32° to 113°F)
4.75 to 5.25 Vdc, 1 A
2.4 GHz @ 7dBm
NOTICE
counter clockwise to unlock it.
, and the fuse
.
NOTICE
6).
Parking Mode Cable Wiring Diagram
Item
Wire Color
Black
Yellow
Red
Connecting the Parking Mode Cable Accessory to
Power
Garmin strongly recommends having an experienced installer
with the proper knowledge of electrical systems install the
device. Incorrectly wiring the power cable can result in damage
to the vehicle or the battery and can cause bodily injury.
1
Route the parking mode cable accessory to a location in the
vehicle with constant power, switched power, and a ground
connection.
2
Connect the BATT wire to a constant power source.
3
Connect the ACC wire to a switched power source.
4
Connect the GND wire to the bare metal of the vehicle's
chassis using an existing bolt or screw.
5
Plug the parking mode cable accessory into the USB port on
the camera.
My camera feels warm while it is operating
It is normal for the camera to feel warm during typical use,
especially while it is recording high-resolution video or
transmitting a Wi‑Fi signal.
.
Wire Function
Ground
Battery 12 V
Accessory 12 V
CAUTION
Troubleshooting
Appendix