Garmin GMR FANTOM OPEN ARRAY Series Installationsanleitung Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Schiffsausrüstung Garmin GMR FANTOM OPEN ARRAY Series herunter. Garmin GMR FANTOM OPEN ARRAY Series 19 Seiten.
Seite drucken
Installation Procedures
Preparing the Radar Mounting Surface
Before you can mount the radar, you must choose a suitable mounting location
page 2).
1 Secure the included mounting template to the surface at the mounting location, along the bow-stern axis, as
indicated on the template.
2 Drill the mounting holes using a 15 mm (
3 If you need to run the power and network cables through the mounting surface, select a location along
the center channel indicated on the template, drill a pass-through hole for the cables using a 32 mm
1
(1
/
in.) drill bit, and route the cables through the surface (optional)
4
page 7).
4 Remove the mounting template from the surface.
Mounting the Radar
Before you can mount the radar, you must select a mounting location
prepare the mounting surface
1 Place the radar onto the mounting surface, aligning the holes on the base of the radar with the holes you
drilled when preparing the mounting surface.
2 Apply the included Petrolatum Primer to the threads of the four threaded rods.
3 Insert the threaded rods
6 mm hex wrench.
To avoid damaging the pedestal, you should stop tightening the threaded rods when they no longer turn
easily.
4 From under the mounting surface, place the included plastic shoulder washers
and into the holes.
19
/
in.) drill bit.
32
(Preparing the Radar Mounting Surface,
through the mounting surface and into the radar base, and tighten them using a
(Mounting Considerations,
(Wiring and Connection Considerations,
(Mounting Considerations,
page 3).
over the threaded rods
page 2) and
3