AEG 40809 Gebrauchsanweisung - Seite 36

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Waschmaschine AEG 40809 herunter. AEG 40809 40 Seiten.

Installation and connection instructions

Water connections

The washing machine is provided with safety equipment that prevents

dirty water from flowing backwards into the drinking water supply

pipes, in accordance with national water company specifications.

Therefore there is no need to use any other additional protection in

the installation.

Warning! Washing machines designed to be connected to a cold water

pipe must not be supplied with hot water!

Allowable water pressure

The water pressure shall be not less than 0,5 bar (= 0.05 MPa) and not more

than 8 bar ( = 0,8 MPa).

Install a pressure reducer if the pressure exceeds 8 bar.

If the pressure is below 0,5 bar, unscrew the supply pipe on the

magnetic inlet valve on the washing machine, and remove the flow

regulator (to do this, you will need to remove the filter using pliers,

and then rubber washer under it). Then put the filter back into

position. This work can only be done by a qualified installer.

Water supply

A 1.5 m long supply pipe is provided with the washing machine.

If you need to use a longer supply pipe, only use a complete set of pipes

fitted with installed screw-on end pieces, supplied by our After Sales

Service.

Warning! Never use odd pieces of pipe as extensions!

Sealing rings are supplied either inside the plastic nuts, or with the

accessories supplied with the washing machine. Do not use other

sealing rings!