Brother TD-4420TN Benutzerhandbuch - Seite 40

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Drucker Brother TD-4420TN herunter. Brother TD-4420TN 44 Seiten. Cutter module
Auch für Brother TD-4420TN: Installationshandbuch (2 seiten)

Seite drucken

6. Troubleshooting

This chapter explains how to resolve typical problems you may encounter when using the printer. If
you have any problems with the printer, first make sure you have performed the following tasks
correctly.
If you still have problems, contact the product manufacturer's customer service or your local dealer.
Problem
The LED Indicator is not lit.
- The Brother Printer
Management Tool shows
Head Open.
- The LED flashes in red.
- The Brother Printer
Management Tool shows
Out of Ribbon or Ribbon
Encoder Err.
- The LED flashes in red.
- The Brother Printer
Management Tool shows
Out of Paper.
- The LED flashes in red.
- The Brother Printer
Management Tool shows
Paper Jam.
- The LED flashes in red.
I cannot print.
Memory full
(FLASH/DRAM).
Possible Cause
The Power Cord is not correctly
connected.
The Print Head mechanism is
open.
 The ribbon has run out.
 The ribbon is installed
incorrectly.
 The label has run out.
 The label is installed
incorrectly.
 The Gap/Black Mark Sensor
is not calibrated.
 The Gap/Black Mark Sensor
is not calibrated.
 Make sure label size is set
correctly.
 Labels may be stuck inside
the Printer Head mechanism.
 The cable is not connected
to the serial or USB
interface.
 The serial port cable is not
correctly connected.
The FLASH/DRAM storage is
full.
36
Solution
 Make sure the printer is correctly
connected to the power outlet (electrical
socket) using the Power Cord.
 Turn the printer on.
Close the Print Head mechanism.
 Install a new ribbon roll.
 To install a new ribbon roll, see
section 3.2.
 Install a new label roll.
 To install a new label roll, see section 3.3.
 Calibrate the Gap/Black Mark Sensor.
 Calibrate the Gap/Black Mark Sensor.
 Set the label size correctly.
 Re-connect the serial or USB cable.
 Try a new cable.
 Use a correct ribbon or media.
 Check the ribbon for damage.
 Reinstall the ribbon.
 Clean the Print Head.
 Adjust the print density and print speed.
 The Print Head's harness connector is not
connected correctly with the Print Head.
Turn off the printer and plug the connector
again.
 Make sure that your program contains the
PRINT command at the end of the file and
a CRLF at the end of each command line.
Delete unused files from the FLASH/DRAM.