Brother TJ-4420TN Setup-Handbuch

Blättern Sie online oder laden Sie pdf Setup-Handbuch für Etikettenhersteller Brother TJ-4420TN herunter. Brother TJ-4420TN 4 Seiten. Label peeler module

Seite drucken

Setup Guide

Label Peeler Module (PA-LP-006)

TJ-4420TN/4520TN/4620TN

NOTE

• Only Authorized Brother Dealers or Certified Technicians should perform

this optional installation.

• For more information about installation and use, contact your local

Brother office.

• Disconnect the printer's AC Power Cord from the AC power outlet (electrical

socket) before installing or removing the Label Peeler to avoid the risk of

electrical shock.

• When installing the Label Peeler, do not twist, severely bend, pinch, or bind

any cords. This may cause damage or malfunction.

• After installation or removal, DO NOT leave tools or hardware inside the label

printer, otherwise an electrical shock may occur, or the machine may get

damaged or destroyed by static electricity.

• DO NOT touch the printer parts with your bare hands as these parts may get

damaged or destroyed by static electricity. Before touching the printer parts,

place the printer on an Electrostatic Discharge (ESD) grounding mat or use

anti-static gloves.

• Make sure not to lose the screws or other small parts during installation.

• DO NOT place the machine on an unstable surface, such as a table or shelf. If

the machine falls, injuries may occur.

Media Guide Bar and Rear Label Guide

For the specific Label Printer part names, see section 2.2 Printer Overview in your

label printer's User's Guide.

A. Install the Label Peeler Module

1. Open the Media Cover.

2. Remove the two Screws and pull out the Lower Front Panel.

3. Remove the two Screws and then remove the Lower Bar.

Ver. 02