Fujitsu PRIMERGY RX200 S3 Start Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Start Handbuch für Server Fujitsu PRIMERGY RX200 S3 herunter. Fujitsu PRIMERGY RX200 S3 8 Seiten.
Auch für Fujitsu PRIMERGY RX200 S3: Handbuch für Service-Ergänzungen (49 seiten)

Seite drucken

Fujitsu PRIMERGY RX200 S3 Start Handbuch

Conditions

n Restriction of installation features

When installing this server, avoid the following areas.

��

��℃��℃

��

- In dusty areas, dust will stick to the front and backside of the server for a short period of time. Since it causes

failure, changing the installation place is recommended.

- Noise level of this server is measured at 58dB. It is recommended to place the server in an exclusive room.

Use the server with care if it is placed in an office.

■ Install the server into the rack

- Be sure to secure rack with stabilizers to prevent the

device tipping over. For details on installing the rack,

refer to the "Installation Guide for the RACK" and the

manual provided with the rack.

- The weight of the server exceeds 18kg. When you carry

the server, have the right and left sides and the bottom of

the server by two or more people.

Open both the front and rear doors of

the rack.

Remove the inner rail from the slide rail.

��

Attach the inner rail to the server.

Set the screws on the server side in the holes of the rail

(1), and slide the rail forward to fix it (2).

��

�

��

�

Check where to attach the slide rail.

Attach the slide rail to the front and rear brackets.

Attach the rack nuts to the front brackets.

��

Attach the slide rail provided in this kit

to the rack holes.

Insert the projections from the back side in the rack,

and attach the slide rails with M5 flathead screws

and washers.

And then, fix the front side in the same way.

��