Fujitsu SPARC Enterprise M8000 Produkthinweise - Seite 39
Blättern Sie online oder laden Sie pdf Produkthinweise für Server Fujitsu SPARC Enterprise M8000 herunter. Fujitsu SPARC Enterprise M8000 44 Seiten. For xcp version 1041
Auch für Fujitsu SPARC Enterprise M8000: Handbuch "Erste Schritte (4 seiten), Merkmale Handbuch (30 seiten), Ergänzendes Handbuch (36 seiten)
Seite drucken
Specific Issues and Workarounds Concerning Solaris (Continued)
TABLE 6
CR ID
Description
6559504
Messages of the form nxge: NOTICE:
nxge_ipp_eccue_valid_check: rd_ptr = nnn
wr_ptr = nnn will be observed on the console
with the following cards:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
6563785
Hot-plug operation with the following cards
might fail if a card is disconnected and then
immediately reconnected:
• SG-XPCIE2SCSIU320Z Sun StorageTek
PCI-E Dual-Port Ultra320 SCSI HBA
• SGXPCI2SCSILM320-Z Sun StorageTek
PCI Dual-Port Ultra320 SCSI HBA
6564332
Hot-plug operations on Sun Crypto
Accelerator (SCA)6000 cards can cause SPARC
Enterprise M8000/M9000 servers to panic or
hang.
6564934
Performing a DR deleteboard operation on a
board which includes Permanent Memory
when using the following network cards will
result in broken connections:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
6568417
After a successful CPU DR deleteboard
operation, the system panics when the
following network interfaces are in use:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
6571370
Use of the following cards have been observed
to cause data corruption in stress test under
laboratory conditions:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
Workaround
These messages can be safely ignored.
After disconnecting a card, wait for a few
seconds before re-connecting.
Version1.0 of the SCA6000 driver does not
support hot-plug and should not be attempted.
Version1.1 of the SCA6000 driver and
firmware will support hot-plug operations
after the required bootstrap firmware upgrade
has been performed.
Re-configure the affected network interfaces
after the completion of the DR operation. For
basic network configuration procedures, refer
to the if manpage for more information.
Add the following line to /etc/system and
reboot the system:
set ip:ip_soft_rings_cnt=0
Add the following line in /etc/system and
reboot:
set nxge:nxge_rx_threshold_hi=0
SPARC Enterprise M8000/M9000 Servers Product Notes
29