Fujitsu FI-5900C Erste Schritte - Seite 13

Blättern Sie online oder laden Sie pdf Erste Schritte für Scanner Fujitsu FI-5900C herunter. Fujitsu FI-5900C 30 Seiten. Consumable replacement and cleaning instructions
Auch für Fujitsu FI-5900C: Erste Schritte (30 seiten), Handbuch für Installationsverfahren (7 seiten), Handbuch für Installationsverfahren (9 seiten), Installationsverfahren (3 seiten), Broschüre & Specs (2 seiten), Ergänzendes Handbuch (4 seiten), Broschüre & Specs (4 seiten), Anweisungen zum Austausch von Verbrauchsmaterialien und zur Reinigung (24 seiten), Ersetzungsverfahren (22 seiten), Anweisungen zur Reinigung (2 seiten)

Seite drucken

3. Press the "I" side of the main power switch to

turn on the scanner.

■ Connecting the SCSI interface

When using the scanner with a SCSI interface, the fol-

lowing SCSI cable and SCSI card must be purchased.

• SCSI cable

Use a SCSI cable whose connector on the scan-

ner side is the 68-pin high-density shielded-type

and whose connector on the PC side fits the con-

nector of the SCSI card to use.

It is recommended to use a cable of length 1.5 m

or shorter.

• SCSI card

Find the recommended SCSI card information

on the Fujitsu web site (FAQ).

http://www.fujitsu.com/global/support/

computing/peripheral/scanners/scsi/

•

When connecting the SCSI cable, turn

ATTENTION

the scanner off. Be sure to connect the

SCSI cable first, and then turn on the

power of the scanner and PC.

•

In a SCSI daisy chain configuration,

connect the scanner so that it is the ter-

minated device.

1. Insert the SCSI cable into the interface connec-

tor of the scanner until both sides click.

2. Connect the other end of the cable to your PC.

Be careful not to bend the pins of the SCSI

ATTENTION

cable when connecting to the scanner.

OFF

fi-5900C Image Scanner Getting Started

3. Set the SCSI ID using the SCSI ID switch on

the back of the scanner.

The SCSI ID is initially set to "5" at the factory.

If the SCSI ID of another SCSI device is set to the

same ID, either change the scanner's SCSI ID or

SCSI ID of the other SCSI device.

ID No.

0 to 7

Can be set as the ID

Works with the factory default value

8, 9

(SCSI ID = 5).

When the scanner is turned on, the SCSI ID set is

enabled.

4. Press the "I" side of the main power switch to

turn on the scanner.

■

When using VRS

When using the Kofax® VRS, you need to connect it to

the exclusive VRS board with either the USB cable or

SCSI cable.

1. If you use the USB cable, insert it into the inter-

face connector (1) shown below.

If you use the SCSI cable, insert it into the

interface connector (2) shown below.

SCSI ID Switch

2. Connect the other end of the cable to your PC.

Description

OFF

VRS board