Fujitsu fi-6110 Handbuch "Erste Schritte - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Scanner Fujitsu fi-6110 herunter. Fujitsu fi-6110 9 Seiten. Image scanner
Auch für Fujitsu fi-6110: Handbuch "Erste Schritte (9 seiten)

Seite drucken

Test-Scanning Documents

Using ScandAll PRO, you can test-scan
documents to check if they are scanned correctly.
The following describes how to test-scan a
document:
1.
Press the [Power] button on the operator
panel of the scanner.
The power is turned on, and the [Power]
button lights in green.
During initialization, the Function Number
Display of the operator panel changes as
follows: "8"
"P"
scanner is ready when "1" is displayed.
If "1" is not shown in the Function
Number Display, refer to "Chapter 8
Troubleshooting" in the Operator's
Guide.
When you press the [Power] button,
the Check LED will flash once. Note
that this is an initial diagnosis and not
a malfunction.
2.
Turn on your computer.
The scanner is automatically detected.
When the [Found New Hardware]
dialog box appears, select [Locate and
install driver software
(recommended)], and install the driver
by following the on-screen
instructions.
3.
Load a sheet into the scanner.
1. Pull out the chute extension 1 and chute
extension 2 according to the length of the
sheet.
2. Load the document in the ADF paper chute.
Set the sheet with its front side (scanning
side) facing the ADF paper chute.
3. Adjust the side guides to the width of the
sheet.
Check LED
Check
Function
Function
Number
Send to
Display
Scan
/Stop
Power
[Power] Button
"0"
"1". The
4. Lift up the stacker and stacker extension
according to the length of the sheet.
Side Guides
Stacker
Extension
4.
Launch ScandAll PRO.
Select the [Start] menu
[Fujitsu ScandAll PRO]
5.
Select the [Tool] menu
The [Setup] dialog box appears.
6.
On the [Scan] tab, select a driver to use,
and then click the [OK] button.
To use a TWAIN driver, click [TWAIN].
To use an ISIS driver, click [ISIS/VRS].
7.
Select the [Scan] menu
Scanner].
The [Select Scanner] dialog box appears.
8.
Select the scanner you want to use, and
then click the [Select] button.
Select the scanner model which is connected
to your computer.
The list of scanner models varies depending
on the scanner driver installed.
TWAIN Driver
FUJITSU fi-6110dj
9.
Click the [Scan] menu
The [Scan Settings] dialog box appears.
10.
Clear the [Save to file] check box.
You only check the operation now, so
you do not have to save to file.
11.
Click the [Scanner Setting] button.
The scanner driver's setup dialog box
appears.
7
Chute
Extension 2
Chute
Extension 1
Stacker
[All Programs]
[ScandAll PRO].
[Preferences].
[Select
ISIS Driver
Fujitsu fi-6110
[Scan Settings].