Brother DCP-9040CN Schnellstart-Handbuch - Seite 10

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Druck-Server Brother DCP-9040CN herunter. Brother DCP-9040CN 10 Seiten. Facsimile equipment
Auch für Brother DCP-9040CN: Broschüre & Specs (4 seiten), Handbuch zur Schnelleinrichtung (30 seiten), Handbuch (7 seiten), Teile-Referenzliste (43 seiten), Handbuch zur Schnelleinrichtung (31 seiten), Reinigung und Pflege (7 seiten), Handbuch zur Schnelleinrichtung (20 seiten)

DCP9040CN, DCP9045CDN, MFC9440CN & MFC9840CDW

a. Remove the screwdriver (or other object) used to hold the cam in figure 1.

b. Pushing the roller holder assembly fully to the top of the machine should cause the cam to move

forward. The roller holder assembly should remain locked in the UP position.

c. Pushing the cam toward the back of the machine should cause the roller holder assembly to drop.

The cam should remain in this position.

d. If this behavior is observed, the repair is successful. Secure the frame assembly with the three

screws removed in figure 6. Proceed with reassembly of the machine. LEAVE THE CAM

ASSEMBLY PUSHED TOWARDS THE REAR OF THE MACHINE.

e. If the machine does NOT behave as described, the lift arm is not in the correct position. Repeat the

procedure, beginning with step 5. IT IS NOT NESSCARY TO COMPLETELY REMOVE THE

ASSEMBLY FROM THE MACHINE – SIMPLY SLIDE IT TO THE RIGHT.

Note: Check the bush 7 holder, to make sure it is installed properly and did not clip off.

11. Now you can finish reassembling the machine in reverse order.

NO PAPER FEED Message, Clicking Noise

March 3, 2008

The Bush 7 is not clipped on properly.

The Bush 7 is clipped on properly.

Page 10 of 10

SERVICE

UPDATE No.

F1249