Fujitsu ETERNUS DX Disk Konfigurationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Konfigurationshandbuch für Lagerung Fujitsu ETERNUS DX Disk herunter. Fujitsu ETERNUS DX Disk 28 Seiten. Server connection, fcoe for linux driver settings for converged network adapter cards
Auch für Fujitsu ETERNUS DX Disk: Benutzerhandbuch (35 seiten), Benutzerhandbuch (42 seiten), Konfigurationshandbuch (28 seiten), Konfigurationshandbuch (44 seiten), Konfigurationshandbuch (29 seiten), Konfigurationshandbuch (25 seiten), Konfigurationshandbuch (32 seiten), Konfigurationshandbuch (35 seiten), Konfigurationshandbuch (31 seiten), Konfigurationshandbuch (43 seiten), Konfigurationshandbuch (21 seiten), Konfigurationshandbuch (24 seiten)

Chapter 3

Notes

3.2

Server Startup and Power Supply Control Notes

3.2

Server Startup and Power Supply Control Notes

Before turning the server on, check that the ETERNUS DX/AF storage systems and LAN switches are all

"Ready". If the server is turned on and they are not "Ready", the server will not be able to recognize the

ETERNUS DX/AF storage systems.

Also, when the ETERNUS DX/AF power supply is being controlled by a connected server, make sure that the

ETERNUS DX/AF does not shut down before the connected servers. Similarly, the LAN switches must also be

turned off after the connected servers have been shut down.

If turned off, data writes from the running server cannot be saved to the ETERNUS DX/AF storage systems,

and already saved data may also be affected.

3.3

To enable Jumbo Frame, all the connected devices must support Jumbo Frame. Set the appropriate values

•

for various parameters (such as the MTU size) on each connected device.

For details about how to set Jumbo Frame for a LAN card and LAN switch, refer to the OS and each device's

•

manuals. Rebooting the server may be required to apply the new settings.

The MTU size that is supported by the ETERNUS DX/AF is 9,000 bytes.

•

3.4

When configuring an iSCSI Boot environment, use the path of the assigned CM (Primary) for the LUN where

•

the OS is to be installed as the path for the configuration (or OS installation).

During operation, use the path of the assigned CM (Primary) for the LUN where the OS is installed as the

•

boot path.

Use the path of the unassigned CM (Secondary) as the standby path that is only used for maintaining re-

•

dundancy when a failure occurs.

After the failure is recovered, perform a boot again using the path of the assigned CM (Primary).

•

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (iSCSI) for Oracle Solaris

P3AM-4042-18ENZ0