Fujitsu ETERNUS DX80 Konfigurationshandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Konfigurationshandbuch für Lagerung Fujitsu ETERNUS DX80 herunter. Fujitsu ETERNUS DX80 16 Seiten. Disk storage system
Auch für Fujitsu ETERNUS DX80: Setup-Handbuch (4 seiten), Benutzerhandbuch (35 seiten), Benutzerhandbuch (42 seiten), Setup-Handbuch (4 seiten), Verwendung optionaler Produkte (2 seiten), Konfigurationshandbuch (28 seiten), Verwendung optionaler Produkte (2 seiten), Produkt-Einführung (19 seiten), Inhalt des Pakets (4 seiten), Handbuch (4 seiten)

Chapter 2

Setting Up the ETERNUS DX

2.3

*2: When multiple ESX servers share ETERNUS DX LUNs, any ETERNUS DX CA port that connects a shared

LUN to an ESX server must be assigned to the same reset group, whether multi-paths are used for the

ESX servers or not.

Example: When multiple ESX servers share ETERNUS DX LUNs, CM#0 CA#0 Port#1 and CM#1 CA#0 Port#1

must be assigned to the same reset group, even for single-path configurations.

LAN switch#1

2.2.2

Setting the Subsystem Parameters (for HP-UX only)

Disable the [Load Balance] parameter in "Set Subsystem Parameters" screen. This prevents sense responses

that require access retries from being issued when the ETERNUS DX is overloaded.

For HP-UX server, improper logs may be recorded unless sense response is restricted. Therefore, "Load Bal-

ance" should be disabled. (Sense response should be restricted.)

Note that changing the "Load Balance" setting has no affect on non-HP-UX servers.

2.3

Checking the WWNs

Use ETERNUS Web GUI to check the WWN of each ETERNUS DX. They are required for connecting the ETERNUS

DX to the server.

Server#1

HBA#1

CM#0

Port#1

Affinity-Group

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Server#2

HBA#1

LAN switch#2

CM#1

Port#1

P3AM-3182-15ENZ0