AEG ProSense LF694ABC Benutzerhandbuch - Seite 31

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Waschmaschine AEG ProSense LF694ABC herunter. AEG ProSense LF694ABC 40 Seiten.

Seite drucken
The appliance does not fill
with water properly.
The appliance does not
drain the water.
The appliance door is open
or not closed correctly.
Internal fail. No communica‐
tion between electronic ele‐
ments of the appliance.
The mains supply is unsta‐
ble.
The anti-flood device is on.
If the display shows other alarm codes, deactivate and activate the
appliance. If the problem continues, contact the Authorised Service Centre.
In case of different problem with the washing machine check the table
below for possible solutions.
Problem
The programme does not
start.
The appliance fills with water
and drains immediately.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For this infor‐
mation, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the inlet hose has no kinks, damages or bends.
•
Make sure that the connection of the water inlet hose is correct.
•
Make sure that the filter of the inlet hose and the filter of the valve are not clog‐
ged. Refer to 'Care and cleaning'.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Make sure that the drain filter is not clogged. Clean the filter, if necessary. Re‐
fer to "Care and cleaning".
•
Make sure that the connection of the drain hose is correct.
•
Set the drain programme if you set a programme without drain phase.
•
Set the drain programme if you set an option which ends with water in the tub.
•
Make sure that the door is properly closed.
•
The programme was not finished properly or the appliance stopped too early.
Switch the appliance off and on again.
•
If the alarm code appears again, contact the Authorised Service Centre.
•
Wait until mains supply is stable.
•
Disconnect the appliance and close the water tap. Contact the Authorised
Service Centre.
Possible solution
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance door is closed.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the Start/Pauze has been touched.
•
If the delay start is set, cancel the setting or wait for the end of countdown.
•
Deactivate the Child Lock function if it is on.
•
Check the position of the knob on the selected programme.
•
Make sure that the drain hose is in the correct position. The hose may be posi‐
tioned too low. Refer to "Installation instruction".
ENGLISH
31