AEG 200372733 Gebrauchsanweisung - Seite 21

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kühlschrank AEG 200372733 herunter. AEG 200372733 32 Seiten. Aeg refrigerator freezer combination instruction manual

Seite drucken

Some useful information and advice

1. The variable shelves are worth paying attention to, which increases the usabil-

ity of the fresh food compartment considerably. Rearranging the shelves is

also possible when the door is open at an angle of 90°.

2. After opening and closing the door of the freezer vacuum will rise inside the

appliance because of the low temperature. So wait 2-3 minutes after closing

the door - if you want to open it again - while inner pressure equalises.

3. Take care of opening the freezer at a position of thermostatic control so that

the inside temperature can never be warmer than -18 C.

4. It is practical to make sure of faultless operation of the appliance daily so as

to notice possible failure in time and prevent deterioration of frozen foods.

5. Normal operating sounds:

A thermostat controls the compressor and you will hear a faint click when

thermostat cuts in and out.

You may hear faint gurgling or bubbling sound when the refrigerant is

pumped through the coils at the rear, to the cooling plate/evaporator.

When the compressor is on, the refrigerant is being pumped round and you

will hear a whirring sound or pulsating noise from the compressor.

The fridge evaporator (this part cool down the fridge section) is foamed

into the cabinet. The temperature

of this part changing during its

work, and parallel with this its

dimensions are slightly changing,

too. These changes might cause a

cracking noise, which is a natural,

harmless phenomenon.

6. Should you want to check the tem-

perature of food stored in the refrig-

erator, place a glass of water cen-

trally in the cabinet, and put a prop-

er thermometer with an accuracy of

+/- 1 °C into it. If after 6 hours you

measure a value around that seen on

the display, the refrigerator works

properly. The measuring shall be performed under steady-stated conditions

(without changing the load).

7. If the freezer temperature is measured using a thermometer, put it between

the products since this will reflect the real temperature in the frozen prod-

ucts. It is normal that the built-in temperature display shows a temperature

slightly above that measured in other ways.