Brother 2 Handbuch - Seite 19

Blättern Sie online oder laden Sie pdf Handbuch für Software Brother 2 herunter. Brother 2 39 Seiten. Hewlett-packard laser printer user guide
Auch für Brother 2: Benutzerhandbuch (15 seiten)

Seite drucken

To perform trial feeding, touch

• For details, see "Trial Feeding" on page 21.

To change the cutting start position, touch

• For details, see "Changing the Cutting Start Position" on

page 22.

Touch the "Start" key to start cutting.



When cutting is finished, the machine stops at the bottom of

the pattern.

Note

• Before cutting, always make sure that there are no grooves

or objects placed near the ejection slot. The leader sheet

may get caught in a groove or bump against an obstacle,

and may not feed well.

To cut off the material at the point where cutting stopped,

select "Finish".



Instructions for feeding the material appear. Confirm the

details, and then touch the "OK" key.



The material is fed until the bottom of the pattern reaches

trimmer on the base attachment.

Memo

• To continue cutting additional patterns without cutting off

the material, select "Continue to cut". For details, see

"Continuous Cutting" on page 23.



Instructions for cutting off the material appear.

• Touch

to confirm the instructions.

Install the trimmer over the material.

Align the holes in the trimmer with the pins in the base

attachment.

a Hole in trimmer

b Pin on base attachment

Firmly press the trimmer down on the right side of the

material. While holding them in place, slide the trimmer

blade from right to left to cut off the material.

Slide the trimmer blade while pressing down gently.

• This will create a cut leaving a 10 mm (0.4") margin at the

bottom of the pattern.

• To stop the operation and feed out the material before cutting

it off, press

to feed the material out toward you.

a Trimmer

b Trimmer blade

Note

If the material does not cut easily:

• If cutting does not start smoothly, for example, if the

material catches on the blade, instead of sliding the blade

with excessive force, refer to the following and try again.

Sliding the trimmer blade with excessive force may cause

damage.

- If the material is not very pliable, firmly press the

trimmer down on the right side of the material.

- If the material is fairly pliable and has a strong curl,

firmly press the trimmer down at the center.