AEG OKO-SANTO 2842-6 i Betriebs- und Installationsanleitung - Seite 14
Blättern Sie online oder laden Sie pdf Betriebs- und Installationsanleitung für Kühlschrank AEG OKO-SANTO 2842-6 i herunter. AEG OKO-SANTO 2842-6 i 14 Seiten. Integrating fridge freezer
Auch für AEG OKO-SANTO 2842-6 i: Betriebs- und Installationsanleitung (28 seiten)
Seite drucken
5.
Check the water drain hole on
the rear wall of the fridge. Clear
a blocked drain hole with the
aid of the drain cleaning tool
included with the appliance.
6.
When everything is dry place
appliance back into service.
Energy Saving Tips
• Do not install the appliance near cookers, radiators or other sources
of warmth. High ambient temperatures cause longer, more frequent
operation of the compressor.
• Ensure sufficient air circulation and exhaust at the appliance base
and at the back wall of the appliance. Never cover air vent ope-
nings.
• Do not place warm foods into the appliance. Allow warm foods to
cool first.
• Only leave door open as long as necessary.
• Do not set temperature any colder than necessary.
• Put frozen food in the fridge to defrost. The cold in the frozen food
will then be used to cool the fridge.
Accumulation of dust at the condenser increases energy consump-
tion. For this reason carefully clean the condenser at the back of the
appliance once a year with a soft brush or a vacuum cleaner. Ensure
the appliance is switched off.
14
Something Not Working
If the appliance is not functioning correctly, please carry out the fol-
lowing checks before contacting your local AEG Service Force Cen-
tre.
Warning!
Repairs should only be carried out by qualified service engineers.
Repairs carried out by inexperienced persons may cause injury or
serious malfunctioning.
Malfunction
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Appliance does not work.
Fuse has blown or is defec-
tive.
Socket is defective.
Appliance cools too much.
Temperature is set too cold. Turn the temperature regu-
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
The food is too warm.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Interior lighting does not
Light bulb is defective.
work.
Heavy build up of frost, pos-
Door seal is not air tight
sibly also on the door seal.
(possibly after changing
over the hinges).
Possible Cause
Remedy
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
lator to a warmer setting
temporarily..
Please look in the "Initial
Start Up" section.
Open the door only as long
as necessary.
Turn the temperature regu-
lator to a colder setting tem-
porarily.
Please see "Installation
location" section.
Please see "Changing the
Light Bulb" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (not hotter
than approx. 50 °C). At the
same time shape the war-
med door seal by hand such
that it sits correctly.
15