Brother ADS-4300N Handbuch zur Schnelleinrichtung - Seite 8
Blättern Sie online oder laden Sie pdf Handbuch zur Schnelleinrichtung für Scanner Brother ADS-4300N herunter. Brother ADS-4300N 11 Seiten.
Auch für Brother ADS-4300N: Schnellstart-Handbuch (11 seiten), Schnellstart-Handbuch (10 seiten)
Seite drucken
Product Safety Guide
Federal Communications
Commission (FCC)
Supplier's Declaration
of Conformity (USA only)
Responsible Party:
declares, that the products
Product Name: ADS-3100/ADS-3300W/ADS-4300N/
ADS-4700W/ADS-4900W
comply with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This
device may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
Consult with an experienced radio/TV
technician for help.
(Wireless network models only)
This transmitter must not be co-located or
operated in conjunction with any other antenna
or transmitter.
IMPORTANT
• Changes or modifications not expressly
approved by Brother Industries, Ltd. could void
the user's authority to operate the equipment.
• A shielded interface cable should be used
to ensure compliance with the limits for a
Class B digital device.
8
Brother International Corporation
200 Crossing Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700
Compliance with FCC requirement
15.407(c) (ADS-4900W only)
Data transmission is always initiated by software,
which is the passed down through the MAC, through
the digital and analog baseband, and finally to
the RF chip. Several special packets are initiated
by the MAC. These are the only ways the digital
baseband portion will turn on the RF transmitter,
which it then turns off at the end of the packet.
Therefore, the transmitter will be on only while one
of the aforementioned packets is being transmitted.
In other words, this device automatically discontinue
transmission in case of either absence of information
to transmit or operational failure.
Frequency Tolerance: ±20ppm
Industry Canada
Compliance Statement
(Canada only)
This device complies with Industry Canada's
licenceexempt RSSs. Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
Le present appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisee
aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioelectrique
subi, meme si le brouillage est susceptible d'en
compromettre le fonctionnement.
For indoor use only (5150 MHz - 5350 MHz)
(ADS-4900W only)
Pour usage intérieur seulement (5150 MHz - 5350 MHz)
(ADS-4900W uniquement)
For use in the USA or
Canada only
These machines are made for use in the USA and
Canada only. We cannot recommend using them
overseas because the power requirements of your
machine may not be compatible with the power
available in foreign countries. Using USA or Canada
models overseas is at your own risk and may void
your warranty.