Fujitsu Flash-64P-M01 Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Handbuch für Hauptplatine Fujitsu Flash-64P-M01 herunter. Fujitsu Flash-64P-M01 21 Seiten.

Seite drucken
Fujitsu Flash-64P-M01 Handbuch
RST0 / RST1 (J9)
DTR / /DTR (J10)
Figure 9: J9, J10 jumper setting for Reset Generation (default: RST0/RST1= 1-2,
DTR/ /DTR = 1-2)
1.4.6 Configuration of the analog Interface
The jumpers J2, J3 and J4 are used to configure the analog interface. J2 is used to
connect the analog ground AVss to the digital GND, J3 is used to connect the
analog power supply voltage AVcc to Vcc. Via jumper J4 the analog reference
voltage AVR can be selected.
J2 (AVss=GND)
J3(AVcc =Vcc)
J4(AVR=AVcc)
Figure 10: J2, J3, J4 jumper setting for the analog Interface (J2(AVss)=ON,
J3(AVcc)=ON, J4(AVR=AVcc)=ON)
Jumper setting
1-2 (RST0)
2-3 (RST1)
1-2 (DTR)
2-3 (/DTR)
DIP switch setting
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON(closed)
OFF (open)
Flash-64P-M01/M09
Description
DTR of UART0 used to
generate Reset
DTR of UART1 used to
generate Reset
No polarity inversion
for the DTR signal
Polarity inversion for
the DTR signal
(J2, J3, J4)
Description
AVss = GND(Analog
Ground = Digital
Ground)
AVss disconnected
AVcc=Vcc(Analog
Voltage Supply =
Digital Voltage supply
Vcc)
AVcc not connected
AVR=AVcc(Analog
Reference Voltage =
Analog Supply voltage
AVcc)
AVR defined by
resistor network R5/R6
Page 12