Fujitsu SK-AMAPOLLO-BASE-V11 Benutzerhandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Hauptplatine Fujitsu SK-AMAPOLLO-BASE-V11 herunter. Fujitsu SK-AMAPOLLO-BASE-V11 46 Seiten. Ambiq micro apollo 1 / 2 evaluation board
Seite drucken
1.2 Overview
The SK-APOLLO-BASE is used with Apollo1 or Apollo2 breakout boards (not included).
After setting the jumpers for Apollo 1 or Apollo 2 usage the following features of the
baseboard can be used:
-
Arduino UNO headers
o 5 Analog pins (or digital pins)
o 16 digital pins
o I2C interface
o SPI interface
-
RGB LED
-
2 Buttons
-
1 Reset Button
-
USB to Serial Wire Debug (SWD), CMSIS-DAP compatible
-
USB to UART
-
USB to power measurement
The breakout board itself has an additional "BLE" connector where an external BLE chip can
be connected. For Apollo 1 only UART is supported by this connector. For Apollo 2 UART
and SPI can be used.
Figure 0-1: Overview EVK-Apollo-Baseboard
Figure 0-2: Apollo 1 / 2 Breakout-Board
© Fujitsu Electronics Europe GmbH
FEEU Ultra-Low-Power Apollo Evaluation Kit Platform
Chapter 1 Introduction SK-APOLLO-BASE
- 9 -
EEU-UG-2017120001-10