Indesit 47857 Informationen zum Dienst - Seite 13

Blättern Sie online oder laden Sie pdf Informationen zum Dienst für Waschmaschine Indesit 47857 herunter. Indesit 47857 23 Seiten.

F08: Heater relay stuck on or pressure switch stuck on full

Check wiring to heater and continuity of element (31 ohms approximately).

Check operation of pressure switch (water levels normal etc.), and efficiency of pressure switch

wiring and connections.

Check pressure chamber is not blocked with sludge.

Check efficiency of module edge connector J3 and associated wiring.

Remove edge connector J3 and check wiring and contacts at positions 2, 3 and 4.

If all above are OK, replace module, eeprom or pressure switch as required.

F09: Machine set up error

Check if module has a soldered eeprom replace module and eeprom

Check if module has a plug-in eeprom, check eeprom is correctly connected to socket on

module.

If all above are OK replace module or eeprom as required.

F10: No full or empty signal from pressure switch

If machine will allow you to. Check water levels are correct.

Check efficiency of module edge connector J3.

Remove module edge connector J3 check wiring and contacts at positions 1, 2, 3 and 4.

Check efficiency of wiring and connection plug on pressure switch.

If all the above are OK replace pressure switch, module or wiring as required.

F11: Drain pump disconnected

Check that the pump connection plug is connected to pump securely.

Test continuity of pump windings (165 ohms).

Check efficiency of module edge connectors J9.

Remove module edge connector J9 and check wiring and contacts at positions 8 and 9.

If all above are OK replace module or eeprom as required.

F12: No communication between Console Board and Power Module

Check efficiency of edge connector J11 and edge connector on control panel.

Remove module edge connector J11 and check wiring and contacts.

Remove edge connector on control board check wiring and contacts.

If all above OK replace control board, power module or eeprom as required.

F13: High Temperature Rise in Drying

Reduced air flow through dryer heater assembly

Check operation of fan motor

Check dryer filter for blockage

F14: No Heat in Drying

Check one shot thermostat

Check heater, valve and fan motor module connections, edge connector J10

F15: No Drying

Possible dryer relay open circuit

F16: N/A