Indesit W 84 TX Handbuch für Installation und Gebrauch - Seite 30

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Waschmaschine Indesit W 84 TX herunter. Indesit W 84 TX 40 Seiten.

Seite drucken

Indesit W 84 TX Handbuch für Installation und Gebrauch

Here I'm in command

Making the right choice is important. And it's easy.

Programme selector knob

and programmed start

Use this knob to select the wash

programme.

Turn this knob clockwise only.

To select a programme, you

should turn the knob so that the

symbol/number of the desired

programme is in line with the

pointer on the knob.

Now press on/off button H

(position I), pilot lamp I will start

flashing.

After 5", the setting will be

accepted, pilot lamp I will stop

flashing (staying lit) and the wash

cycle will begin.

Should you wish to interrupt the

programme in progress or set a

new one, select one of the

symbols (Stop/Reset) and wait

5" : when the cancellation has

been accepted, pilot lamp I

flashes, and you can then turn the

appliance off.

You can use this knob to delay

the appliance's operation.

Select one of the four delay time

positions, press the on/off button

H (position I) and wait 5". The

setting has now been accepted

(pilot lamp I stays lit) and you can

select the programme you desire.

Pilot lamp I has a particular

flashing motion (2" on and 4" off)

to indicate that a delayed start

has been set.

During this phase, you can open

the appliance door and change

the washing load, should you

wish to do so.

After the wash cycle has been set

and accepted by the washing

machine, turning the knob will

have no effect (except for when

it is on position

Stop/Reset).

The detergent dispenser with the

additional bleach compartment

is here.

Instructions for installation and use

Temperature control knob

It is used to set the wash tempe-

rature in the recommended

programme table on pag. 28. It

also allows you to reduce the tem-

perature recommended for the

selected programme, and even to

set a cold wash cycle ( ).

Spin exclusion knob

It is used to exclude the spin

cycle (by choosing symbol

or to reduce the spin speed of

the selected programme. The

maximum speed for the four

types of fabric are:

Fabric

Speed

Cotton

800 rpm

Synthetics

800 rpm

Wool

600 rpm

Silk

Note: distribution phase will be

carried out at low speed.

Detergent dispenser

It is divided into three

compartments:

1. Detergent for pre-wash;

2. Detergent for the main cycle

wash;

3. Fabric conditioner.

Understanding the control panel

The washing machine is

equipped

with

compartment 4 (provided as an

accessory) for the bleach, to be

inserted in compartment 1.

Extra Economy

Reduces water consumption

during the rinse cycles. We

recommend that you use this

function only with small laundry

loads, dosing the detergent

proportionally.

)

Rapid wash

This button reduces the length

of the wash programme by

about 30%. It cannot be used

with special programmes (see

page 28) or those for wool and

silk.

Stain removal (see page 31)

Thanks to this command, the

washing machine will carry out

a more intensive wash that

optimises the effectiveness of the

liquid additives, thus allowing

more resistant stains to be

removed. When you press the

stain removal button, you cannot

activate the pre-wash.

On-off

When button H is pressed, the

washing machine is switched

on, when it is not the machine

is switched off.

Turning the appliance off

does not cancel the selected

programme.

extra

The on-off lamp

Lamp I flashes when the

appliance is switched on and

awaiting a programme to be set.

A steady light means the

appliance has accepted the

selected programme.

The door block lamp

The safety lamp indicates that the

washing machine door is locked

to prevent it from being opened

accidentally. To avoid any

damages to lock mechanism,

you must wait for the lamp to

extinguish, before attempting to

open the door which takes around

three minutes.

Anti-crease

This function (represented by the

symbol

) interrupts the wash

programme, keeping the washing

soaking in water before draining.

It is only enabled in programmes

for synthetic fabrics, silk and

curtains. It is very useful,

because it prevents delicate and

synthetic fabrics from creasing

(for example, when you cannot

take the washing out at the end

of the wash cycle but only a few

hours later). The programme can

be completed by turning knob A

one notch. In the case of

synthetic fabrics, should you

prefer draining rather than a spin

cycle, turn knob A until you have

selected the symbol

(Drain).