Indesit FDEF31111 Informationen zum Dienst - Seite 3
Blättern Sie online oder laden Sie pdf Informationen zum Dienst für Geschirrspüler Indesit FDEF31111 herunter. Indesit FDEF31111 20 Seiten.
Seite drucken
- 1. Table of Contents
- 2. Safety Notes & General Servicing Advice
- 3. General Information and Console Panel
- 4. VIRTUAL SENSORS Description and Operation
- 5. Additional Component Descriptions
- 6. Auto Test Cycle
- 7. Fault Codes & Diagnostics
- 8. Thermistor Resistance Chart
- 9. Wiring Diagram
- 10. General Dishwashing Information
Indesit
Company
GENERAL INFORMATION
Programme Start Delay
AFTER STARTING A PROGRAMME THERE WILL BE A DELAY BEFORE THE CYCLE STARTS,
ALTHOUGH THE DISPLAY WILL BEGIN TO COUNT DOWN.
THIS DELAY CAN BE UPTO 5 MINUTES, THIS IS NOT A FAULT WITH THE MACHINE and
CANNOT BE CHANGED BY REPLACING PARTS or REPROGRAMMING.
THERE MAY ALSO BE SHORT DELAYS DURING THE WASH PROGRAMMES.
Introduction
PLP2 Dishwashers are a New Innovation Version of the Current Dishwasher Range (EOS, 2007 to
current 2013).
These models have a DEA700 Module, with a BLAC Wash Pump and Drain Pump, Virtual Sensors
are used to monitor the quantity of water in the machine. The Pressure Switch has been eliminated.
Some Models also feature a Ozone Generator incorporated into the Dispenser.
A New Detergent/Rinse Aid Dispenser on some models incorporating an Ozone Generator.
The Ozone Generator prevents the formation of bacteria consequently minimizing unpleasant smells
inside the tub and generally improving hygiene conditions internally of the appliance.
Top End Models also have a Third Upper Cutlery Tray with a shower head in the roof of the
Dishwasher supplied by a continuation of the Upper Spray Arm Feed Pipe.
DEMO MODE
LCD Models Only
Activation:
1.
Make certain the machine is Off at the Console with Mains power On.
2.
Switch the machine On, then Off.
3.
Press and hold the Start/Pause button, and at the same time (within 5 seconds), press and hold
On/Off for 10 seconds. A confirmatory "Beep" will be heard.
4.
The message "DEMO ON" is displayed.
5.
Demo Mode can be aborted by disconnecting the appliance from the power supply or follow the
Deactivation sequence below.
Deactivation:
1.
With the machine Off at the Console, press and hold the Start/Pause button, and at the same
time - within 5 seconds - press and hold On/Off for 2 seconds.
2.
A confirmatory "Beep" will be heard and the message "DEMO OFF" is displayed.
3.
Demo Mode can also be aborted by disconnecting the appliance from the power supply.
Service Manual UK
3 of 20
English