Indesit IDL 505 Handbuch für Installation und Gebrauch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Geschirrspüler Indesit IDL 505 herunter. Indesit IDL 505 17 Seiten. Indesit dishwasher installation and use
Auch für Indesit IDL 505: Handbuch für Installation und Gebrauch (17 seiten)

Seite drucken

Turning on the Appliance

First of all.

Turn on the water tap completely and press ON-OFF button

"A". you will hear a short beep and indicator light "B" lights

up. Now the appliance is on and awaiting instructions.

Starting and selecting the cycle.

Turn the cycle selector knob "D" clockwise until the reference

notch on the knob corresponds with the number or symbol

for the cycle you wish to set (consult the wash cycle table on

page 7, especially when first using the appliance).

If the appliance door is shut, press the Start button "R" and

you will hear a beep; the cycle will start up within a few

seconds.

Cycle phase indicator lights

The dishwasher is provided with 4 indicator lights "G" which

come on in sequence as the appliance is performing that

specific phase of the wash cycle.

These phases are:

pre-wash,

wash,

Cancelling or modifying a wash cycle in progress.....

Premise: You can cancel the wash cycle in progress, if it has

only just started.

To modify a wash cycle, keep the RESET button "R" pressed

for about 5 seconds: a prolonged beep will sound, followed

by three short beeps. Indicator light "G" will turn off and at

this point, all the settings will have been cancelled.

To select a new wash cycle, repeat the operations illustrated

in the paragraph entitled "starting and selecting the cycle".

Warning: the knob must be turned clockwise from wash

cycle 1 to 5, an anti-clockwise from wash cycle 5 to 1.

rinses,

drying

If you have left out a dish...

You can interrupt a wash cycle by pressing the ON-OFF

button, then place the dishes you had left out into the

appliance, which will start up from where it was interrupted

when you turn it back on.

There's been a power failure? Have you opened the

dishwasher door?

The wash cycle stops and then restarts when the electricity

comes back on or when the door is shut.

At the end of the wash cycle....

The end of the wash cycle is indicated by two short beeps

and the flashing of the drying phase indicator light.

• Press button "A" to turn the appliance off.

• Turn off the water tap.

• Wait a few minutes before unloading the dishes: if you

wait a little while, they dry better thanks to the steam.

• Empty the lower rack first.

Warning: when you open the dishwasher door after the wash

cycle has just ended or is under way, take care not to scald

yourself with the hot steam.