Indesit I6MG1G / EX Betriebsanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Backofen Indesit I6MG1G / EX herunter. Indesit I6MG1G / EX 16 Seiten.

Seite drucken

HOOD

600

Min.

mm.

blinds behind the cooker or less than 200 mm away

from its sides.

• Any hoods must be installed according to the

instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the

appliance, screw the adjustable

feet into the places provided on

each corner of the base of the

cooker (see figure).

The legs* fit into the slots on the

underside of the base of the

cooker.

Electrical connection

Install a standardised plug corresponding to the load

indicated on the appliance data plate (see Technical

data table).

The appliance must be directly connected to the mains

using an omnipolar circuit-breaker with a minimum contact

opening of 3 mm installed between the appliance and the

mains. The circuit-breaker must be suitable for the charge

indicated and must comply with current national legislation

(the earthing wire must not be interrupted by the circuit-

breaker). The supply cable must be positioned so that it

does not come into contact with temperatures higher than

50°C at any point.

Before connecting the appliance to the power supply,

make sure that:

• The appliance is earthed and the plug is compliant with

the law.

• The socket can withstand the maximum power of the

appliance, which is indicated by the data plate.

* Only available in certain models

•

Do not position

• The voltage is in the range between the values

indicated on the data plate.

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it. Do

not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only.

! The manufacturer declines any liability should

these safety measures not be observed.

IF THE FITTED PLUG IS REMOVED*

The flexible mains lead must be correctly connected as

below to a three pin plug of not less than 13 amp capacity.

If a B.S. 1363 fused plug is used, it must be fitted with a

fuse which is approved to B.S. 1362.

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow - Earth

- Neutral

Blue

- Live

Brown

The power supply cable must be type H05VV-F

Blue to

Neutral

Cord

Clamp

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

Connect the Green & Yellow wire to terminal marked "E"

or coloured Green or Green & Yellow.

Connect the Brown wire to the terminal marked "L" or

coloured Red.

Connect the Blue wire to the terminal marked "N" or

coloured Black.

FAILURE TO OBSERVE THE ACCIDENT-PREVENTION

REGULATIONS RELIEVES THE MANUFACTURER OF

ALL LIABILITY.

Green &

Yellow to

Earth

Brown

to Live

3 Amp

Fuse