Indesit KN1G2 S/E Handbuch für Installation und Gebrauch - Seite 18

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Backofen Indesit KN1G2 S/E herunter. Indesit KN1G2 S/E 28 Seiten. Indesit k1i2/e; k1g2/e; k1i2 s/e; k1g2 s/e; kn1i2 s/e; kn1g2 s/e gas ovens with grill

Seite drucken

c) Minimum regulation of the hob burners:

•

turn the tap to minimum;

•

remove the knob and adjust the regulation screw, which

is positioned in or next to the tap pin, until the flame is

small but steady.

N.B.: in the case of natural gas, the adjustment screw

must be unscrewed by turning it anti-clockwise.

•

check that the flame does not turn off when you turn

the tap quickly from high to low.

d) Regulating the primary air of the burners:

The primary air of the burners requires no regulation.

Adapting the gas oven to different types of gas

a) Replacing the oven burner nozzle:

•

remove the warming drawer;

•

remove the sliding protection "A" (see Fig.C);

•

remove the screw and then the oven burner "V"(see

Fig. D). Remove the oven door to facilitate this

operation.

•

unscrew the oven burner nozzle using the special

socket spanner for the nozzles (see Fig. E), or better

still a 7 mm socket spanner, and replace it with a nozzle

suited to the new type of gas (see table 1).

Fig. C

b) Minimum regulation of the oven burner without

thermostat:

•

light the burner as described in the paragraph "the oven

knob" of the instruction booklet;

•

take the knob to minimum, indicated by .

•

remove the knob and turn the regulation screw which

is positioned in or next to the tap pin until the flame is

small but steady.

•

check that the burner does not turn off when you turn

the knob from high to low or when you open and close

the oven door quickly.

N.B.: in the case of natural gas, the adjustment screw

must be unscrewed by turning it anti-clockwise.

Fig. D

Fig.E

Adapting the gas grill to different types of gas

Replacing the nozzle of the grill burner:

•

remove the screw and then slide out the grill burner "V"

(see Fig. F);

•

unscrew the grill burner nozzle using the special socket

spanner for the nozzles (see Fig. G) or better still a 7 mm

socket spanner; replace the nozzle with a nozzle for the new

type of gas (see table 1).

Fig. F

Pay particular attention to the plug wires and

thermocouple tubes.

Important

On completion of the operation, replace the old rating

sticker with one indicating the new type of gas used. This

sticker is available from our Service Centres.

Note

Should the pressure of the gas used be different (or vary)

from the recommended pressure, it is necessary to fit a

suitable pressure regulator onto the inlet pipe in

compliance with current National Regulations relative to

"regulators for channelled gas".

Fig. G