Indesit 15GG0 Betriebsanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Herde Indesit 15GG0 herunter. Indesit 15GG0 24 Seiten. Cooker and oven

Seite drucken

1. Description of the Appliance

• Fits firmly into place at both ends, where it will

be fixed using clamps that comply with current

regulations.

! If one or more of these conditions is not fulfilled

or if the cooker must be installed according to the

conditions listed for class 2 - subclass 1 appliances

(installed between two cupboards), the flexible steel

hose must be used instead (see below).

Connecting a flexible jointless stainless steel pipe to

a threaded attachment

Make sure that the hose and gaskets comply with

current national legislation.

To begin using the hose, remove the hose holder on the

appliance (the gas supply inlet on the appliance is a

cylindrical threaded 1/2 gas male attachment).

! Perform the connection in such a way that the hose

length does not exceed a maximum of 2 metres,

making sure that the hose is not compressed and does

not come into contact with moving parts.

Checking the connection for leaks

When the installation process is complete, check the

hose fittings for leaks using a soapy solution. Never

use a flame.

Adapting to different types of gas

It is possible to adapt the appliance to a type of gas

other than the default type (this is indicated on the

rating label on the cover).

Adapting the hob

Replacing the nozzles for the

hob burners:

1. Remove the hob grids and

slide the burners off their seats.

2. Unscrew the nozzles using

a 7 mm socket spanner (see

gure), and replace them with

nozzles suited to the new type

of gas(see Burner and nozzle speci cations table).

3. Replace all the components by following the above

instructions in reverse.

Adjusting the hob burners' minimum setting:

1. Turn the tap to the minimum position.

2. Remove the knob and adjust the regulatory screw,

which is positioned inside or next to the tap pin, until

the flame is small but steady.

! If the appliance is connected to a liquid gas supply,

the regulatory screw must be fastened as tightly as

possible.

3. While the burner is alight, quickly change the position of

the knob from minimum to maximum and vice versa several

times, checking that the flame is not extinguished.

! The hob burners do not require primary air

adjustment.

Adapting the oven

Replacing the oven burner

nozzle:

1. Remove the oven

compartment.

2. Slide out the protection panel

(see diagram).

3. Remove the oven burner

after unscrewing the screws V

(see gure).

The whole operation will be

made easier if the oven door is

removed.

4. Unscrew the nozzle using a

special nozzle socket spanner

(see gure) or with a 7 mm

socket spanner, and replace it

with a new nozzle that is suited to the new type of gas

(see Burner and nozzle speci cations table).

Adjusting the gas oven burner's minimum setting:

1. Light the burner (see Start-up and Use).

2. Turn the knob to the minimum position (MIN)

after it has been in the maximum position (MAX) for

approximately 10 minutes.

3. Remove the knob.

4. Tighten or loosen the adjustment screws on the

outside of the thermostat pin (see gure) until the flame

is small but steady.

! If the appliance is connected to liquid gas, the