Indesit HGK 150.B IX Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Herde Indesit HGK 150.B IX herunter. Indesit HGK 150.B IX 48 Seiten. Built-in cooker

Seite drucken

The appliance must be installed only by a qualified

person in compliance with the instructions provided.

The manufacturer declines all responsibility for improper

installation which may harm persons and animals and

damage property.

Important: The power supply to the appliance must be

cut off before any adjustments or maintenance work is

done on it.

Installation of Built-in Ovens

In order to ensure that the built-in appliance functions prop-

erly, the cabinet containing it must be appropriate. The

figure below gives the dimensions of the cut-out for instal-

lation under the counter or in a wall cabinet unit.

580

555

595

N.B.: Installation in compliance with the consumption declaration

In order to ensure adequate ventilation, the back panel of

the cabinet unit must be removed. Installing the oven so

that it rests on two strips of wood is preferable. If the oven

rests on a continuous, flat surface, there must be an ap-

erture of at least 45 x 560 mm.

The panels of the adjacent cabinets must be made of heat-

resistant material. In particular, cabinets with a veneer ex-

terior must be assembled with glues which can withstand

temperatures of up to 100 °C.

In compliance with current safety standards, contact with

the electrical parts of the oven must not be possible once

it has been installed.

All parts which ensure the safe operation of the appliance

must be removable only with the aid of a tool.

To fasten the oven to the cabinet, open the door of the

oven and attach it by inserting the 4 wooden screws into

the 4 holes located on the perimeter of the frame.

Instalation

Electrical Connection

The cooker must be connected to the mains electricity

supply. The hob is connected to the cooker using a special

connector. The cookers are designed to operate on

alternating current featuring the supply voltage and

frequency indicated on the appliance data plate.

560

+4 -0

558

min

Fitting on a Power Supply Cable

Opening the terminal board:

•

To install the cable, proceed as follows:

•

Using a screwdriver, prise on the side tabs of the

terminal board cover;

Pull open the cover of the terminal board.

unscrew the wire clamp screw and the contact screws

Note: the jumpers are factory-set for a three-phase

400V connection (fig. D).

to make the electrical connections illustrated in fig. F

and fig. G, use the two jumpers housed in the box (fig.

E - reference "P")

fasten the supply cable in place with the clamp and

close the cover of the terminal board.

nly on

certain models