Indesit KN6E117/RU Betriebsanleitung - Seite 13

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Herde Indesit KN6E117/RU herunter. Indesit KN6E117/RU 25 Seiten. Cooker and oven

Seite drucken

Installation

! Before operating your new appliance please read

this instruction booklet carefully. It contains

important information concerning the safe installation

and operation of the appliance.

! Please keep these operating instructions for future

reference. Make sure that the instructions are kept

with the appliance if it is sold, given away or moved.

! The appliance must be installed by a qualified

professional in accordance with the instructions

provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected

from the electricity supply.

Positioning and levelling

! It is possible to install the appliance alongside

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall in contact with the back of

the appliance is made from a non-flammable, heat-

resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the bed-

sit (not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 600 mm

away from them.

HOOD

600

Min.

mm.

are flammable ( see figure ).

• Do not position blinds behind the cooker or less

than 200 mm away from its sides.

• Any hoods must be installed according to the

instructions listed in the relevant operating

manual.

Levelling

• If the cooker is

installed underneath a

wall cabinet, there must

be a minimum distance

of 420 mm between

this cabinet and the top

of the hob.

This distance should

be increased to 700

mm if the wall cabinets

If it is necessary to level the

appliance, screw the

adjustable feet into the places

provided on each corner of the

base of the cooker ( see

figure ).

The legs* fit into the slots on

the underside of the base of

the cooker.

Electrical connection

Fitting the power supply cable

To open the terminal board:

• Insert a screwdriver into the side tabs of the

terminal board cover.

To install the cable, follow the instructions below:

• Loosen the cable clamp screw and the wire

contact screws.

! The jumpers are pre-set at the Factory for 230 V

single-phase connection ( see figure ).

230V ~

H05RR-F/ 3x4 CEI-UNEL 35363

H05VV-F/ 3x4 CEI-UNEL 35746

• To carry out the electrical connections as shown in

the figures, use the two jumpers inside the box

( see figure - labelled "P").

Only available in certain models.

• Pull the cover to

open it.