AEG TSC7M181DS Benutzerhandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kühlschrank AEG TSC7M181DS herunter. AEG TSC7M181DS 28 Seiten.
Seite drucken4.8 Extra Freeze function
Extra Freeze function is used to pre-freeze
and fast freeze in sequence in the freezer
compartment. This function accelerates the
freezing of fresh food and, at the same time,
protects foodstuffs already stored from
undesirable warming.
To freeze fresh food, activate the Extra
Freeze function at least 24 hours before
placing the food to complete pre-freezing.
To activate this function, press the Extra
Freeze button.
The Extra Freeze indicator lights up. The
Extra Freeze function stops automatically
after a maximum of 52 hours.
Press the Extra Freeze button to deactivate
the Extra Freeze function before it
automatically ends.
4.9 High temperature alarm
When the temperature in the freezer
compartment increases (for example due to
an earlier power failure), the alarm indicator
flashes, the freezer temperature indicator
shows H° and blinks and the sound is on.
To deactivate the alarm, press any button.
The alarm indicator and sound go off. The
freezer temperature indicator shows H° for 5
seconds before indicating the freezer
temperature again.
The alarm restarts one hour after
deactivation until the normal conditions
are restored.
If you do not press any button, the sound
switches off automatically after around
one hour to avoid disturbing.
4.10 Door open alarm
If the fridge door is left open for
approximately 5 minutes or if the freezer door
is left open for approximately 80 seconds, the
sound is on and the door open alarm
indicator turns on. The internal fridge light
may also start flashing.
The alarm stops after closing the door. Press
any button to switch off the sound.
If you do not press any button, the sound
switches off automatically after around
one hour to avoid disturbing.
4.11 Air filter change indicator
When the air filter has expired and requires
replacement, the Air filter change indicator
and the Filter Reset alarm indicator turn on.
Refer to "Installing and replacing the CleanAir
+ filter" section in "Care and cleaning"
chapter for the replacement instructions.
After the filter replacement, press the Filter
Reset alarm button to turn off the alarm.
4.12 Setting mode
The Setting mode allows you to:
• Enable or disable the ECOMETER
indicator
• Enable or disable the button sounds
• Change the temperature units from °C to
°F
• Reset the appliance to factory settings
Activating the Setting mode
To activate the Setting mode:
1. Press and hold the ECO button for
approximately 3 seconds. When the
Setting mode is being activated, the
display shows a blinking
2. Once the Setting mode is switched on,
the display shows
To deactivate the Setting mode, press and
hold the ECO button for approximately 3
seconds.
The Setting mode deactivates automatically if
you do not interact with the control panel for
60 seconds.
Navigating the Setting mode
1. Activate the Setting mode (refer to
"Activating the Setting mode").
The display shows
2. Tap the fridge temperature button (on the
left) to change the parameter. Tap the
.
.
.
ENGLISH
11