Indesit EcoTime IDVL 75 B R.9 Gebrauchsanweisung - Seite 14
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trockner Indesit EcoTime IDVL 75 B R.9 herunter. Indesit EcoTime IDVL 75 B R.9 16 Seiten.
Troubleshooting
If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the
GB
Technical Assistance Centre
The dryer does not start.
•
The plug has not been inserted far enough into the socket to make contact.
•
There has been a power cut.
•
The fuse has burned out. Try connecting another appliance to the same socket.
•
If an extension cord is used, try connecting the dryer plug directly into the socket.
•
The door has not been closed properly.
•
The programme has not been set correctly (see How to carry out a drying cycle).
START/PAUSE
•
The
•
On machines equipped with "Locked" function, check the option is not enabled (see Programmes and options).
The drying cycle does not start.
•
A delayed start time has been set (see Programmes and options).
START/PAUSE
•
The
to start; do not press the
not start.
Drying times are too long.
• The filter has not been cleaned (see Care and maintenance).
• The heat setting is not suited to the type of fabric to be dried (see Programmes and options).
• An incorrect drying time was selected for the type of load (see Laundry).
• The flexible ventilation hose may be blocked (see Installation).
• The air inlet may be blocked or obstructed (see Installation).
• The fixed ventilation flap, on the protective weatherproof cover, may be obstructed (see Installation).
• The items are too wet (see Laundry).
• The dryer is overloaded (see Laundry).
The programme is fi nished but the items are damper than expected.
!
For safety reasons, the dryer programmes last a maximum of 5 hours. If an automatic programme has not detected the final
dampness level required in this interval, the dryer completes the
the programme; if the items are still damp, contact the Technical Assistance Centre (see Assistance).
The dryer is noisy during the fi rst few minutes of operation.
•
This is normal, especially if the dryer has not been used for a long time. If the noise persists during the entire cycle, contact
the Technical Assistance Centre.
The lights on the dryer control panel are off although the dryer is switched on.
The dryer has gone into standby mode to save power. This occurs if you have left the dryer on or have had a power cut. It
occurs after 30 minutes:
- if you leave the dryer without starting a programme;
- after your drying programme has finished.
Turn the knob to the desired program to restart dryer operation (to start the program press START/PAUSE). The OFF position
switches off the dryer.
14
(see Assistance).
button has not been pressed (see How to carry out a drying cycle).
button has been pressed; a short delay follows before the dryer starts running. Wait for the drying cycle
START/PAUSE
button otherwise the dryer switches to the pause mode and the drying cycle will
programme and stops. Check the above points and repeat