AEG A81000TNW0 Benutzerhandbuch - Seite 12
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Gefrierschrank AEG A81000TNW0 herunter. AEG A81000TNW0 20 Seiten. Built in freezer
Auch für AEG A81000TNW0: Benutzerhandbuch (20 seiten), Benutzerhandbuch (36 seiten)
Seite drucken
12
What to do if...
WHAT TO DO IF...
WARNING!
Before troubleshooting, disconnect the mains plug from the mains socket.
Only a qualified electrician or competent person must do the troubleshooting that is not in
this manual.
There are some sounds during normal use (compressor, refrigerant circulation).
The appliance operates discontinuously, so the stopping of compressor does not mean be-
ing no current. That is why you must not touch the electrical parts of the appliance before
breaking the circuit.
Problem
The appliance is noisy
The compressor operates
continually
There is too much frost
and ice
It is too warm in the
freezer
Possible cause
The appliance is not supported
properly
The thermostatic control is set
incorrectly
Doors are not shut properly or
do not close tightly
The door has been opened too
frequently
Large quantities of food to be
frozen were put in at the same
time
Food placed in the appliance
was too warm
The room temperature is too
high.
Products are not wrapped prop-
erly
Doors are not shut properly or
do not close tightly
The Temperature regulator may
be set incorrectly
Temperature regulator may be
set incorrectly
The door does not close tightly
or it is not shut properly
Solution
Check if the appliance stands sta-
ble (all the four feet should be on
the floor)
Set a warmer temperature
Check if the doors close well and
the gaskets are undamaged and
clean
Do not leave the door open lon-
ger than necessary
Wait some hours and then check
the temperature again
Allow food to cool to room tem-
perature before storing
Decrease the room temperature.
Wrap the products better
Check if the doors close well and
the gaskets are undamaged and
clean
Set a warmer temperature
Set a lower temperature
Check if the door closes well and
the gasket is undamaged and
clean