Kohler Composed K-EX20257T-NW-AF Installationsanleitung Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Armaturen für das Badezimmer Kohler Composed K-EX20257T-NW-AF herunter. Kohler Composed K-EX20257T-NW-AF 14 Seiten. Desk-mount sensor faucet

2.如图所示,将电源线,龙头感应器线
及电磁阀线与相应的接线端相连
接。然后整理好线束并锁紧控制盒
盖。
Solenoid wire connector
注:①为交流电源出线口,使用时,
将①的卡扣(薄片状)去除,保证
出线口光滑。
②为龙头感应器出线口。
三 如何安装排水组件
旋下排水器盘片(19),在其底面沿
周围涂上一圈密封油灰。把排水本
体(20)由底下插入面盆。
把排水器盘片(19)旋入排水本体
(20)。从下方用手拧紧锁紧螺母
(21),去除多余的油灰。
注意: 在锁紧螺母(21)拧紧后,不
可再调整排水本体的位置,否则将
会破坏油灰密封。
把尾管(22)接上存水弯(23),尾管
需插入存水弯25mm到55mm之间。
1495648-T2-A
电磁阀接线端
电源线接线端
Power wire connector
Apply plumbers putty
涂油灰
22
23
2.Cabing and tidying wires such as
power wire assembly,senor wires
assembly and solenoid wire assembly
to right position. Then lock the control
box.
龙头感应线接线端
Sensor wire connector
Note: ① is the outlet of AC power supply.
Remove the clip (lamellar) during the
process of use to ensure the smoothing
of outlet.
② is the outlet of faucet sensor.
How to Install the Drain
19
Screw off the drain flange (19) from drain.
Apply a ring of plumbers putty around
underside of the drain flange (19). Insert
the drain body (20) into the lavatory from
20
the underside.
Thread the drain flange (19) onto the drain
19
Body (20). Tighten the locknut (21) by hand
from the underside of the fixture. Remove
any excess putty.
21
Note:
Do not try to change the position of
20
the drain after the locknut (21) is tightened,
or you may break the putty seal.
Connect the tailpiece (22) to the trap (23).
The tailpiece should extend 25mm to
55mm into the trap.
7