Kohler K-1144 Installationshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Installationshandbuch für Armaturen für das Badezimmer Kohler K-1144 herunter. Kohler K-1144 48 Seiten. Bath whirlpool
Auch für Kohler K-1144: Handbuch für Hausbesitzer (32 seiten), Installationshandbuch (44 seiten), Installationshandbuch (44 seiten), Installationshandbuch (48 seiten)

When installing the pump, make sure

to remove the plugs from the inlet and

outlet piping.

O-Rings

6. Relocate and Mount the Pump

Relocate the pump and in-line heater (if equipped) next to the customized inlet and outlet

connections of the whirlpool harness. The pump may extend beyond the rim of the whirlpool.

Remove all protective packaging from around the whirlpool harness. Cut only those cable ties

supporting the union nuts.

Remove the plugs from the pump inlet and outlet openings. Install the O-rings into the grooves on

the inlet and outlet connector ﬁttings.

Set the pump on the support bracket.

Thread the plastic inlet and outlet attachment nuts onto the pump until the O-rings make initial

contact.

Tighten each nut a quarter turn after initial contact. Do not overtighten these nuts.

NOTE: Do not shim the pump more than 1/2" (1.3 cm). Raising the pump too high will prevent the pump

from priming properly.

Make sure the whirlpool harness inlet piping (suction line) is pitched downward from the pump

toward the suction ﬁtting. This is important so the pump will drain water properly. Shim the pump

if necessary to promote proper drainage.

Secure the pump support bracket with four screws or lag bolts (not provided).

Connect the air actuator tubing to the air switch on the pump.

Kohler Co.

Air Switch

Pump

Provide access to the installed pump for servicing.

Relocate

Pump

1055820-2-A