AEG LAVATHERM 59840 Benutzerhandbuch - Seite 31

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Trockner AEG LAVATHERM 59840 herunter. AEG LAVATHERM 59840 48 Seiten. Condenser dryer with heat pump

AEG LAVATHERM 59840 Benutzerhandbuch

Machine settings

BUZZER permanent off
Water hardness
Water contains, a variable quantity of
limestone and mineral salts of which
quantities vary according to geographi-
cal locations thus varying its
conductivity values.
Relevant variations of the conductivity
of the water compared to those prefixed
by the factory could slightly influence
the residual humidity of the laundry at
the end of the cycle. Your dryer allows
you to regulate the sensitivity of the
drying sensor based on conductivity
values of the water.
Emptying water tank - warning mes-
sage permanent off
When using an external drain for the
condensed water.
Setting
Implementation
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS and SPIN SPEED
buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use BUZ-
ZER button to activate or deactivate sound but ma-
chine does not memorize your selection.
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS and TIME buttons
and hold down for approx. 5 seconds. The current
setting is on the display:
low conductivity <300 micro S/cm
medium conductivity 300-600 micro S/
cm
high conductivity >600 micro S/cm
3. Press the START PAUSE button sequentially until you
set desired level.
4. To memorize setting press simultaneously the DRY-
NESS and TIME buttons or turn knob to OFF position
1. Turn the programme selector to any programme.
2. Press simultaneously the SPIN SPEED and TIME but-
tons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning
icon and
is off
– warning
icon and
is switched on
By default the warning message is switched on and dis-
played always at the end of the drying cycle or during
the cycle if the water container is full.
Machine settings
- warning message
- warning message
31