AEG TR834E94E Benutzerhandbuch - Seite 24

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Trockner AEG TR834E94E herunter. AEG TR834E94E 32 Seiten.

Seite drucken

WARNING!

Deactivate the appliance before carrying out any check.

In case of major problems, the acoustic signals operate, the display shows an error

code and the Start/Pause button may flash continuously:

Error code

Appliance motor overloaded.

E50

Too much laundry or entrap in the drum.

Internal fail. No communication between

electronic elements of the appliance.

E90 or E91

The mains supply is unstable.

EH0

If the display shows other error codes, deactivate and activate the appliance. If the problem

continues, contact the Authorised Service Centre.

In case of different problem with the tumble dryer check the table below for possible solutions.

11.2 Troubleshooting

Problem

The tumble dryer is not connected to the

mains supply.

The door is open.

The tumble dryer

does not operate.

The On/Off button was not pushed.

The Start/Pause button was not touched.

The appliance is in standby mode.

ENGLISH

Possible cause

Remedy

The programme was not completed. Re‐

move the laundry from the drum, set the

programme and restart the cycle.

The programme was not finished properly

or the appliance stoped too early. Switch

the appliance off and on again.

If the error code appears again, contact the

Authorised Service Centre.

When the appliance is showing EH0, please

wait until main supply is stable than press

start. If the appliance pause the cycle with‐

out any indication then press the cycle start.

If the warning will occur check the power

cord / socket integrity or main supply.

Remedy

Connect it to the mains socket. Check the

fuse in the fuse box (domestic installation).

Close the door.

Push the On/Off button.

Touch the Start/Pause button.

Push the On/Off button.