AEG TR8TRIER Benutzerhandbuch - Seite 19
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Trockner AEG TR8TRIER herunter. AEG TR8TRIER 32 Seiten.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level settings.
Adjustment of default dryness
See chapter
level
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
8.12 Drum light on
Touch and hold down Stil button by around 3
seconds.
9. HINTS AND TIPS
9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which are
specified in the programmes chapter.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• The water from the water container can be
used to iron the clothes. You must first
filter the water to eliminate remaining
textile fibres (simple coffee filter is
suitable).
• Always keep the airflow slots at the bottom
of the appliance clear.
• Make sure there is good airflow where the
appliance is to be installed.
9.2 Adjustment of default dryness
level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available programmes.
3. Touch and hold down the Droogtijd and
+ Antikreuk buttons at the same time.
One of the symbols appears on the display:
- Maximum dryness
The light inside the drum is on.
8.13 Possible causes of
unsatisfactory drying results:
• The filter is clogged. Clogged filter makes
drying inefficient.
• The airflow slots are clogged.
• The humidity sensor is dirty.
• The drum is dirty.
• Inadequate default dryness level settings.
Adjustment of default dryness
See chapter
level
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
- Extra dryness
- Standard dryness
4. Touch the Start/Pauze button repeatedly
until you reach the desired dryness level.
Dryness level
Maximum dry‐
ness
Extra dryness
Standard dry‐
ness
5. To memorise the setting touch and hold
down the Droogtijd and + Antikreuk
buttons at the same time for
approximately 2 seconds.
9.3 Deactivating the tank indicator
The water container indicator is activated by
default. It illuminates at the end of the drying
cycle or during the cycle if the water reservoir
is full. If the draining kit is installed the water
container is drained automatically and the
indicator can be deactivated.
To deactivate the indicator:
Display symbol
ENGLISH
19