AEG TR9W75680 Benutzerhandbuch - Seite 25
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Trockner AEG TR9W75680 herunter. AEG TR9W75680 40 Seiten.
Seite drucken
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• The water from the water container
can be used to iron the clothes. You
must first filter the water to eliminate
remaining textile fibres (simple coffee
filter is suitable).
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
10.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available
programmes.
3. Touch and hold down the
Trockenzeit and Knitterschutz
buttons at the same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
4. Touch the Start/Pause button
repeatedly until you reach the
desired dryness level.
Dryness
Display symbol
level
Maximum
dryness
Extra dry‐
ness
Standard
dryness
5. To memorise the setting touch and
hold down the Trockenzeit and
Knitterschutz buttons at the same
time for approximately 2 seconds.
10.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available
programmes.
3. Touch and hold down Leise and
Signal buttons at the same time.
One of 2 configurations is possible:
• the Behälter indicator:
the symbol
water container indicator is
permanently activated
• the Behälter indicator:
the symbol
water container indicator is
permanently deactivated
10.4 Operating hours counter
This function gives a possibility to display
the total operating time of the appliance
in hours, which is counted from the
moment it is first switched on. The actual
operating time of the cycles is shown
(does not include pauses or delayed start
time).
To visualise this value, proceed as
follows:
1. Switch the appliance on by pressing
the Ein/Aus button.
2. Press and hold the Trockenzeit and
Trockengrad buttons for some
seconds.
3. After 3 seconds the total hours
operated by the appliance are shown
in the display: e.g. if the operating
time is 1276 hours, the display shows
the text Hr for 2 seconds then 12 for
2 seconds followed by 76. This value
is displayed with a sequence of two
digits at a time: the first two digits
indicate thousands and hundreds,
the second two digits indicate tens
and units.
ENGLISH
25
is on if
appears - the
is off if
appears - the