Kohler Stillness K-2738T-CP Einbauanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Einbauanleitung für Armaturen für das Badezimmer Kohler Stillness K-2738T-CP herunter. Kohler Stillness K-2738T-CP 4 Seiten. Water supply slide bar
Seite drucken为使安装顺利袁在墙面适当高度预
装 G1/2" 内螺纹管道配件渊5冤遥 使
用 6mm 六角扳手安装进水接头
渊6冤遥
管道配件不能突出或低于装
修好的墙面不超过 15 毫米袁并垂直
于装修好的墙面遥
根据胀塞渊1冤直径袁距离管道配件中
心 711 毫米钻孔遥 将胀塞塞入孔
中遥
客户根据需要选配并安装滑杆装饰
罩渊4冤院2696T尧2697T 或 2698T遥
用自攻螺钉渊3冤安装支撑柱渊2冤遥 调
整支撑柱弧形缺口袁锁紧螺钉固定
支撑柱遥
将销渊8冤旋入支撑柱袁用螺丝刀锁
紧遥
将锁紧组件渊7冤的孔与滑杆的孔对
齐装入遥 如需要袁用螺丝刀调节滑
杆锁紧件的位置遥
将滑杆装到进水接头渊6冤和销上遥
锁紧紧定螺钉渊9,11冤固定滑杆遥 螺
钉渊11冤使用 2mm 六角扳手遥
将盖渊10冤扣到滑杆上遥
1140680-2/Rev00
1
5
4
3
6
10
9
7
2
8
6
11
To perform installation, install G1/2" female
supply fitting(5) at the proper position on
the finished wall. Install inlet connector(6)
with 6mm hex wrench.
2
The supply fitting not extend or below
the finished wall 15mm at most. It is
vertical to the finished wall.
Drill holes according to diameter of the
anchor(1), distance 711mm from the center
of supply fitting. Press the anchor into the
hole.
Customer select and install the slide bar
escucheon渊4冤 2696T,2697T or 2698T.
Connect the mounting post(2) by the
self-tapping screw(3). Adjust the curved
cutout of the post. Tighten the screw to
secure the post.
Thread the pin(8) into the mounting post.
Tighten with a screwdriver.
Line up the hole in the lock assembly(7) with
the hole in the slide bar. If needed, use a
screwdriver to adjust the position of the lock
at end of the slide bar.
Iinstall the slide bar onto the inlet connector
(6) and pin. Secure the slide bar by
tightening the setscrews(9,11). Tighten
screw(11) by 2mm hex wrench.
Press the cap(7) onto the slide bar.