Kohler Symbio K-1336-H Installationshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationshandbuch für Armaturen für das Badezimmer Kohler Symbio K-1336-H herunter. Kohler Symbio K-1336-H 32 Seiten. Bath whirlpool

Seite drucken

Install the Corner Post

Three

Large

Holes

First position and

install the corner post

in the front corner of

the whirlpool

3. Install the Corner Post

CAUTION: Risk of product damage. Do not force the corner post into position, or use it to adjust the

whirlpool height or level.

- Position the corner post in the unsupported front corner of the whirlpool so the three large holes are toward

the side of the unit. Identify the predrilled holes in the wood block on the underside of the whirlpool. Secure

the corner post to the block with the two screws provided. Tighten securely.

- If it is necessary to adjust the height of the corner post, loosen the two hex nuts securing the corner post top

bracket in place. Slide the adjustment bracket up or down as needed to achieve a good fit. You may need to repeat

this step for the bottom bracket. Hand tighten the hex nuts.

- If this whirlpool will be assembled to a receptor and bench, proceed to Attach the Receptor to the Whirlpool"

below. If the whirlpool will be installed alone, proceed to the installation instructions packed with the optional

apron and end panel. Then proceed to Install End Panel" below.

4. Attach the Receptor/Bench to the Whirlpool (Whirlpool/Receptor

Combinations Only)

- If you have not yet assembled the bench to the receptor, do so now by following the instructions packed with the

receptor. Then lift the whirlpool slightly along the outside end, and insert the bench top flange into the groove

underneath the whirlpool rim.

- Position the bench so the side flange is behind the corner post. Align the three fastener holes in the bench with the

holes in the corner post, and loosely fasten the bolts and hex nuts.

- Use a carpenter's square to square the corner post, whirlpool, receptor, and bench with the floor. Secure the corner

post firmly to the floor with two screws.

5. Attach the End Panel to the Whirlpool (Whirlpool Only Installations)

- Lift the whirlpool slightly along the outside end, and insert the end panel top flange into the groove underneath

the whirlpool rim.

- Position the end panel so the side flange is behind the corner post. Align the three fastener holes in the end panel

with the holes in the corner post, and loosely fasten the bolts and hex nuts.

- Use a carpenter's square to square the corner post, whirlpool, and end panel with the floor. Secure the corner post

firmly to the floor with two screws.

Kohler Co.

Whirlpool

Front

Corner

Wood

Block

Predrilled

Holes

Adjustable

Bracket

Screw

Then adjust

the corner

post height

by loosening

the hex nuts

Attach the Receptor/Bench or End Panel

Top

Flange

Receptor/Bench

or End Panel

Side Flange

Screw

Three

Fastener

Holes Corner

Post

Screws

Fit the top

flange into the

groove

Washer

Hex Nut

Lift the

whirlpool

slightly, and

insert the

receptor/bench

or end panel

1012312-2-