Kohler K-1126-S Installationshandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Installationshandbuch für Badewannen Kohler K-1126-S herunter. Kohler K-1126-S 28 Seiten. System basic drop-in bath whirlpool
Seite drucken
Ï Ï
Ï Ï
Ï Ï
Ï Ï
Ï Ï
Í Í
Ï Ï
Î Î Î
Í Í
Î Î Î Î Î Î
Whirlpool
Î Î Î
Î Î Î
Í Í
Î Î Î
Î Î Î
Î Î Î
Î Î
Î Î
7. Complete the Finished Wall
- If you have not already done so, carefully remove the protective tape from the whirlpool rim.
- If a tiling in bead is used, make sure the bead is securely attached to the sides of the whirlpool rim that contact the
stud walls.
- Cover the framing with water resistant wall material. Seal the joints between the whirlpool rim edge and the
water resistant wall material with silicone sealant.
- Tape and mud the water resistant wall material. Install the finished wall to the water resistant wall material. Seal
the joints between the whirlpool rim and the finished wall material with silicone sealant.
- Install the faucet trim according to the instructions packed with the trim.
8. Clean-Up After Installation
- When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the whirlpool
surface. Use warm water and a liquid detergent to clean the surface.
- Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners containing
petroleum distillates to remain in contact with any whirlpool surfaces for long periods of time. Remove plaster
by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a
powder type detergent on a damp cloth to provide mild abrasive action to any residual plaster.
Kohler Co.
Finished Wall Material
Water-Resistant
Wall Material
Apply silicone
sealant to the edges
of the water-resistant
wall material and the
finished wall
Tiling-in Bead
Framing
Whirlpool
7
Finished
Wall
Material
Apply silicone
sealant to the edges
of the water-resistant
wall material and the
finished wall
Water-Resistant
Wall Material
Framing
1011585-2-
A