Kohler K-10611T Installationsanweisung - Seite 21

Blättern Sie online oder laden Sie pdf Installationsanweisung für Toiletten Kohler K-10611T herunter. Kohler K-10611T 27 Seiten. Floor standing toilet

Seite drucken

2. Make sure of h according to dimensions of bowl and then

locate the installation hole of fixing bracket. Mark on the

wall for appropriate position for fixing bracket, and drill four

holes with diameter of 10mm and depth of 80mm with

churn drilling as shown in illustration, and fill in the holes

with bulge screw and tighten the screw to set the fixing

bracket.

Note: Ensure the fixing bracket to remain level.

10mm

80mm

3. Put the tank onto the fixing bracket as shown in the right

figure and adjust the tank to level . Then tighten screws

with hex-head key. Note: it is a must to keep the tank level.

Connect the inlet hose with tank inlet pipe.

Note: 1. Ensure water tank internal valve is OFF.

2. Suggestion: connect a temporary rubber or plastic

hose on valve, flush water supply pipeline. Ensure

water is clean, no residual sand stone or fouling

inside pipeline.

4. Install the mask in the block screen of the tank, and

tighten the screw to fix the mask to the tank.

5. Insert the inlet pipe and drainage pipe into the bowl, and

then adjust the syphon and drainage pipe to a proper

position to be fixed into the bowl. Make sure of the

positions of syphon and discharge elbow and then remove

the bowl.

1263048-T01-D

-13-

Water Pipe

Connecting Pipe

Protective Cover

Discharge Elbow

Drainage Pipe

Bulge Screw

Fixing Bracket

Gasket

Spring

Nut

Level

Tank

Loosen

Tighten

Medium

Allen Key

Screw

Mask

Screw

Water Tank

Syphon

Inlet Pipe