Kohler K-28232X-430 Handbuch für Installation und Pflege - Seite 10

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Pflege für Toiletten Kohler K-28232X-430 herunter. Kohler K-28232X-430 12 Seiten. One-piece toilet

Seite drucken

Troubleshooting Guide

Symptoms

1. Poor flush.

2. No flush.

3. The fill valve

turns on/off by

itself without

the toilet being

flushed or it

runs, allowing

water to enter

the tank.

4. Long tank fill

cycle.

5. Noisy tank fill

cycle.

IMPORTANT: Use only genuine Kohler parts to avoid property damage.

1258066-X2-A

Recommended Action

A. Adjust the tank water level to match the waterline.

B. Fully open the water supply shut-off valve.

C. Clear obstructions from the trapway, jet, or bowl rim

holes.

D. Clear obstructions from the waste line.

A. Reconnect the chain to the trip lever or flush valve.

B. Adjust the chain assembly to remove excessive slack.

A. Adjust the chain for proper slack so flush ball isn't

held off flush valve seat.

B. Clean or replace the flush valve seal if it is worn, dirty,

or misaligned with the valve seat or flush valve seat is

damaged. Replace flush valve seal or flush valve.

C. Clean the fill valve seal of debris or replace the seal

washer assembly.

D. Remove the tank lid and tighten flush valve nut if flush

valve gasket is leaking. Do not overtighten. If leakage

continues, replace gasket.

E. Replace the fill valve if the valve float sinks.

F. Adjust the tank water level if it is too high.

A. Fully open the water supply shut-off valve.

B. Check the flexible supply line (if applicable) for a kink.

Remove the kink.

C. Clean the valve inlet, valve head, or supply line. Flush

lines.

A. Partially close the water supply shut-off valve if the

water pressure to the toilet is too high. Check the

toilet performance following any such adjustment.

B. Remove dirt or obstructions from the valve head.

Flush lines.

Kohler Co.