Kohler Aegis LH640 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Motor Kohler Aegis LH640 herunter. Kohler Aegis LH640 8 Seiten. Horizontal-shaft
Auch für Kohler Aegis LH640: Benutzerhandbuch (21 seiten)

Seite drucken

7. Reinstall oil ﬁ ll cap/dipstick and tighten

securely.

8. Start engine; check for oil leaks. Stop engine;

correct leaks. Recheck oil level.

9. Dispose of used oil and ﬁ lter in accordance

with local ordinances.

Oil Sentry

(if equipped)

™

This switch is designed to prevent engine

from starting in a low oil or no oil condition. Oil

Sentry

may not shut down a running engine

™

before damage occurs. In some applications

this switch may activate a warning signal. Read

your equipment manuals for more information.

Fuel Recommendations

Explosive Fuel can cause ﬁ res

and severe burns.

Do not ﬁ ll fuel tank while engine is

hot or running.

Gasoline is extremely ﬂ ammable and

its vapors can explode if ignited. Store

gasoline only in approved containers, in

well ventilated, unoccupied buildings, away

from sparks or ﬂ ames. Spilled fuel could

ignite if it comes in contact with hot parts or

sparks from ignition. Never use gasoline as a

cleaning agent.

NOTE: E15, E20 and E85 are NOT approved

and should NOT be used; effects of

old, stale or contaminated fuel are not

warrantable.

Fuel must meet these requirements:

● Clean, fresh, unleaded gasoline.

● Octane rating of 87 (R+M)/2 or higher.

● Research Octane Number (RON) 90 octane

minimum.

● Gasoline up to 10% ethyl alcohol, 90%

unleaded is acceptable.

● Methyl Tertiary Butyl Ether (MTBE) and

unleaded gasoline blend (max 15% MTBE by

volume) are approved.

● Do not add oil to gasoline.

● Do not overﬁ ll fuel tank.

● Do not use gasoline older than 30 days.

Fuel Line

Low permeation fuel line must be installed on

carbureted Kohler Co. engines to maintain EPA

and CARB regulatory compliance.

WARNING

KohlerEngines.com

Spark Plugs

Electrical Shock can cause injury.

Do not touch wires while engine

is running.

Clean out spark plug recess. Remove plug and

replace.

1. Check gap using wire feeler gauge. Adjust

gap, see speciﬁ cation table for adjustment.

2. Install plug into cylinder head.

3. Torque plug to 20 ft. lb. (27 N·m).

Air Cleaner

NOTE: Operating engine with loose or

damaged air cleaner components

could cause premature wear and

failure. Replace all bent or damaged

components.

NOTE: Paper element cannot be blown out

with compressed air.

1. Unhook retaining clips and remove end

cap(s).

2. Check and clean inlet screen (if equipped).

3. Pull air cleaner element out of housing and

replace. Check condition of inner element;

replace when dirty.

4. Check all parts for wear, cracks, or damage,

and that ejector area is clean.

5. Install new element(s).

6. Reinstall end cap(s) with dust ejector valve/

screen down; secure with retaining clips.

Breather Tube

Ensure both ends of breather tube are properly

connected.

CAUTION

66 590 05 Rev. --