Kohler Command 6 HP Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Motor Kohler Command 6 HP herunter. Kohler Command 6 HP 17 Seiten. Horizontal crankshaft
Auch für Kohler Command 6 HP: Benutzerhandbuch (16 seiten), Benutzerhandbuch (16 seiten), Benutzerhandbuch (16 seiten)

Kohler Command 6 HP Benutzerhandbuch
Exhaust Pipe
Cooling Air Outlet
Spark Plug
Valve Cover
Choke Lever
Carburetor
Air Cleaner Cover
Oil Sentry
TM
Switch
Closure Plate
Figure 1. Location of Controls and Service Points on C6.

Oil Recommendations

Using the proper type and weight of oil in the crankcase
is extremely important. So is checking oil daily and
changing oil regularly. Failure to use the correct oil, or
using dirty oil, causes premature engine wear and
failure.

Oil Type

Use high quality detergent oil of API (American
Petroleum Institute) service class SG, SH, SJ or
higher. Select the viscosity based on the air
temperature at the time of operation as shown in the
following table.
**
*Use of synthetic oil having 5W-20 or 5W-30 rating is
acceptable.
**Synthetic oils will provide better starting in extreme
cold (below -10°F).
Figure 2. Viscosity Grades Table.
4
Muffler Shield
Retractable Starter Handle
*
3 U.S. Quart
Fuel Tank Cap
Capacity Fuel Tank
Air Cleaner Retaining Knob
NOTE: Using other than service class SG, SH, SJ or
higher oil or extending oil change intervals
longer than recommended can cause engine
damage.
A logo or symbol on oil containers identifies the API
service class and SAE viscosity grade. See Figure 3.
Figure 3. Oil Container Logo.
Refer to "Maintenance Instructions" beginning on
page 8 for detailed oil check, oil change, and oil
filter change procedures.
Start-Stop
Switch (Optional)
TM
Oil Sentry
Light
Fuel Shut-Off
Valve
Control Panel
Throttle Lever
Cooling Air Intake
Retractable Starter
Housing
Oil Drain & Oil Fill/Check
Plug on Opposite Side