Kohler Command CH16 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Motor Kohler Command CH16 herunter. Kohler Command CH16 17 Seiten. Horizontal crankshaft

Seite drucken

NOTE: Upon start-up, a metallic ticking may

occur. This is caused by hydraulic lifter

leakdown during storage. Run the engine

for 5 minutes. The noise will normally

cease in the first minute. If noise

continues, run the engine at mid-throttle

for 20 minutes. If noise persists, take the

engine to your local Kohler Service outlet.

NOTE: If the engine develops sufficient speed to

disengage the starter but does not keep

running (a false start), engine rotation

must be allowed to come to a complete

stop before attempting to restart the

engine. If the starter is engaged while the

flywheel is rotating, the starter pinion and

flywheel ring gear may clash, resulting in

damage to the starter.

If the starter does not turn the engine over, shut

off starter immediately. Do not make further

attempts to start the engine until the condition is

corrected. Do not jump start using another battery

(refer to "Battery"). See your Kohler Engine

Service Dealer for trouble analysis.

3. For a Cold Engine – Gradually return the choke

control to the "off" position after the engine starts

and warms ups.

The engine/equipment may be operated during

the warm up period, but it may be necessary to

leave the choke partially on until the engine warms

up.

4. For a Warm Engine – Return choke to "off"

position as soon as engine starts.

Stopping

1. Remove the load by disengaging all PTO

attachments.

2a. For engines without a shutdown solenoid:

Move the throttle to the ''slow'' or ''low'' idle

position. Allow the engine to run at idle for 30-60

seconds; then stop the engine.

Maintenance, repair, or replacement of the emission control devices and systems, which are being done

at the customers expense, may be performed by any non-road engine repair establishment or individual.

Warranty repairs must be performed by an authorized Kohler service outlet.

WARNING: Accidental Starts!

Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or equip-

ment, disable the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery cable

from battery.

b. For engines equipped with a shutdown

Battery

A 12 volt battery is normally used. Refer to the operating

instructions of the equipment this engine powers for

specific battery requirements.

If the battery charge is not sufficient to crank the engine,

recharge the battery (see page 12).

Operating

Angle of Operation

This engine will operate continuously at angles up to

25°. Check oil level to assure crankcase oil level is at

the "F" mark.

Refer to the operating instructions of the equipment this

engine powers. Because of equipment design or

application, there may be more stringent restrictions

regarding the angle of operation.

NOTE: Do not operate this engine continuously at

Cooling

NOTE: If debris builds up on the grass screen or other

Engine components can get extremely hot from

operation. To prevent severe burns, do not touch these

areas while the engine is running–or immediately after it

is turned off. Never operate the engine with heat

shields or guards removed.

Engine Speed

NOTE: Do not tamper with the governor setting to

Maintenance Instructions

solenoid: Position the throttle control somewhere

between half and full throttle; then stop the engine.

angles exceeding 25° in any direction. Engine

damage could result from insufficient

lubrication.

cooling air intake areas, stop the engine

immediately and clean. Operating the engine

with blocked or dirty air intake and cooling

areas can cause extensive damage due to

overheating.

WARNING: Hot Parts!

increase the maximum engine speed.

Overspeed is hazardous and will void the

engine warranty.