Kohler Command Series Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Motor Kohler Command Series herunter. Kohler Command Series 17 Seiten. Vertical crankshaft
Auch für Kohler Command Series: Benutzerhandbuch (16 seiten), Benutzerhandbuch (20 seiten), Benutzerhandbuch (21 seiten)

Seite drucken

Change Oil Filter

Replace the oil filter at least every other oil change

(every 200 hours of operation). Always use a

genuine Kohler oil filter, Part No. 52 050 02-S.

Replace the oil filter as follows:

1. Drain the oil from the engine crankcase.

2. Remove the oil filter drain plug located at the base

of the oil filter adapter (if so equipped). Allow the

oil filter to drain.

3. Remove the old filter and wipe off the filter

adapter. Reinstall the oil filter drain plug (if so

equipped).

4. Place a new replacement filter in a shallow pan

with the open end up. Pour new oil of the proper

type, in through the threaded center hole. Stop

pouring when the oil reaches the bottom of the

threads. Allow a minute or two for the oil to be

absorbed by the filter material.

5. Apply a thin film of clean oil to the rubber gasket

on the new filter.

6. Install the replacement oil filter to the filter adapter.

Turn the oil filter clockwise until the rubber gasket

contacts the filter adapter, then tighten the filter an

additional 2/3 to 1 turn.

7. Fill the crankcase with new oil of the proper type,

to the "F" mark on the dipstick.

8. Test run the engine to check for leaks. Stop the

engine, allow a minute for the oil to drain down,

and recheck the level on the dipstick. Add more

oil, as necessary, so the oil level is up to but not

over the "F" mark on the dipstick.

Service Precleaner and Air Cleaner Element

This engine is equipped with a replaceable, high

density paper air cleaner element. Most engines are

also equipped with an oiled, foam precleaner which

surrounds the paper element. See Figure 9.

Check the air cleaner daily or before starting the

engine. Check for a buildup of dirt and debris around

the air cleaner system. Keep this area clean. Also

check for loose or damaged components. Replace all

bent or damaged air cleaner components.

NOTE: Operating the engine with loose or damaged

air cleaner components could allow unfiltered

air into the engine causing premature wear

and failure.

Air Cleaner

Cover

w/Knob

Air Cleaner

Element

Screw (2)

Gasket

Figure 9. Air Cleaner Assembly – Exploded View.

Service Precleaner

Wash and reoil the precleaner every 25 hours of

operation, if equipped, (more often under extremely

dusty or dirty conditions).

1. Loosen the air cleaner cover knob and remove the

cover.

2. Remove the precleaner from the paper element.

3. Wash the precleaner in warm water with

detergent. Rinse the precleaner thoroughly until all

traces of detergent are eliminated. Squeeze out

excess water (do not wring). Allow the precleaner

to air dry.

4. Saturate the precleaner with new engine oil.

Squeeze out all excess oil.

5. Reinstall the precleaner over the paper element.

6. Reinstall the air cleaner cover and tighten the

knob securely.

Foam

Precleaner

Wing Nut with

Locking Material

Seal

Stud

Air Cleaner Base