Kohler 10RESVL Installationshandbuch - Seite 21

Blättern Sie online oder laden Sie pdf Installationshandbuch für Tragbarer Generator Kohler 10RESVL herunter. Kohler 10RESVL 48 Seiten. Residential/commercial generator sets
Auch für Kohler 10RESVL: Einbauanleitung (2 seiten)

Seite drucken

Procedure

1. Drill holes for the conduit fittings. See Figure 1-16

for the recommended electrical inlet locations.

Feed the cables through the openings.

2. Connect the leads from the transfer switch

emergency source lugs to the L1 and L2

connections on the generator set terminal block.

3. Connect the neutral (L0) and ground (GRD) leads

from the ATS and the main panel to the

corresponding connection points on the terminal

block. See Section 1.9.1, Grounding.

4. Connect utility power leads to the terminal block

connections labelled UTILITY. Connect to a circuit

that is supplied by the utility source and backed up

by the generator. See Section 1.9.4 for more

information about the utility power requirement.

5. For connection of optional transfer switches, the

programmable interface module (PIM), and/or a

load shed kit, see Section 1.10.

6. To

connect

the

Management System to your generator, run

network cable from the generator set to the

customer's router or modem.

a. Route the network cable with other low-voltage

signal

wiring

communication leads or engine start leads to

the transfer switch), in separate conduit from

the AC load leads. If the network cable is longer

than 100 meters (328 ft.), use a repeater or

switch.

b. Test the internet connection for the generator

by connecting a laptop to the network cable.

(1) Turn OFF any wireless connections to the

laptop.

(2) Connect the network cable to the laptop.

Connect the other end of the network cable

to the customer's router or modem.

(3) Verify the Internet connection by opening

your

web

www.kohlerpower.com or any known

website.

(4) Disconnect the network cable from the

laptop.

c. Use an RJ45 inline coupler to connect the

Ethernet cable to the cable in the customer

connection box. See Figure 1-18. The inline

coupler is included with the OnCue Plus kit.

TP-6984

5/17a

OnCuer

Plus

Generator

(for

example,

the RBUS

browser

and

going

7. When connections to the terminal block are

complete, replace the cover plate.

1. Ground connection for communication cable shield.

2. Low voltage communication and engine start

connections

3. AC power connections

4. Ethernet cable for OnCue Plus connection

5. AC load connections

Figure 1-18 Electrical Connections

1.9.4

AC Power Supply

The installer must connect AC power for the battery

charger (which is integral to the RDC2 controller) and

the optional accessories shown in Figure 1-19. The

power source must comply with state and local codes.

The power to the battery charger and accessories must

be backed up by the generator so that power is available

at all times.

Be sure to disconnect power at the distribution panel

before making the connections. Connect power leads to

the utility power connection points on the terminal block.

See Section 1.9.3 and the wiring diagrams in Section 3

for connection details.

Equipment

Battery charger (stand-

ard)

Carburetor heater *

* Optional accessory

Figure 1-19 Power Requirements

Power Requirement, Max.

Watts

Amps

0.4

0.3

Section 1 Installation

GM88354

Volts

100--250 VAC

50/60 Hz

120 VAC

50/60 Hz