A-Tach 50092 Schnellstart-Handbuch

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Zubehör für Kraftfahrzeuge A-Tach 50092 herunter. A-Tach 50092 2 Seiten.

A-Tach # 50092

Designed for: Jaguar I-Pace 2019 - 20__

For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE

attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the

mount will appear to be a little too big or small for the intended location. The vehicle mount must be

installed BEFORE a device holder is screwed onto the vehicle mount.

Once screwed together the products are considered used and non-refundable.

The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.

Once it is attached, it should remain attached until you would like to permanently remove it.

WARNING:

AVOID extreme heat conditions. It can damage the device and the mount.

(1) Clean the area where the mount will attach. The

mount will attach into the two seams illustrated

with the arrows in the photo.

(3) Remove the covering from the tape. The tape

will not leave any residue if the mount is removed

in the future. Inert the top angled edge of the

mount into the seam next to the seam tool.

See additional instructions on the back side.

ST-1

Mobile Device Mounts

NOTICE: A-Tach Mounts will not be responsible for

any damage to the vehicle due to the installation

and/or use of the product. The product has been

tested to fit securely to the listed vehicles.

Instructions are provided for your convenience.

You are responsible for the use of the product and

to determine if you have the skill to attach the

product without causing damage to your vehicle or

the product.

Read all instructions and view the photos before

attaching this product.

(2) Insert the seam tool into the seam between the

padded dash top and the top of the frame around

the two center vents.

(4) Remove the seam tool from the top seam and

insert the seam tool into the seam between the

display and the bottom of the frame around the

center vents.

A-Tach