dexfrod WS 2200 Betriebsanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Wetterstation dexfrod WS 2200 herunter. dexfrod WS 2200 4 Seiten. Weather station with wireless-thermometer and clock

Seite drucken

WS 2200

Weather Station with wireless-thermometer

and clock

ENGLISH

Operating Instructions

Please read and observe the following information and keep the

operating manual nearby for future reference!

WARNING!

Safety information

 Only use batteries of the same type!

 Always treat batteries with due care and attention and only use

batteries as described.

 Never use standard and rechargeable batteries together. Never use

rechargeable batteries or standard batteries with different capacities or

charge statuses together. Never use standard or rechargeable batteries

which are damaged.

 Risk of suffocation through small objects, packaging and protective foil!

 Keep children away from the product and its packaging!

 Risks to health and the environment from batteries!

 Never open, damage or swallow batteries or allow them to pollute the

environment. They could contain toxic and ecologically harmful heavy

metals.

ATTENTION!

 Prevent exposure to environmental influences, e.g. smoke, dust,

vibration, chemicals, moisture, heat and direct sunlight.

 Only allow repairs to be completed by qualified personnel.

Package contents

1 Weather station main unit, 1 Thermo-sensor, Operating manual

Thermo-sensor

LCD

display

Display icons and operating elements

1 Weather Forecast

2 Indoor temperature, humidity, trend ➙ ➚ ➘

3 Outdoor temperature, trend ➙ ➚ ➘

4 Snooze

5 Time

6 Date

7 Comfort index

8 Sensor symbol

9 Alarm

10 Hanging hole

11 Battery compartment cover

12 Table stand

A SET

B ALARM

C CHANNEL

D DOWN (Press the key to switch between °C or °F)

E UP

F SNOOZE

G SNOOZE / LIGHT

a Change from °C / °F

b Change channel

During initial installation, the unit may take up to an hour or more to

acclimatise to current conditions. It is recommended to put the main

unit in the room where it will be used at least 1 hour prior to initial

installation.

STARTING UP

 After inserting the batteries, the station is now connecting to the

thermo sensor. This process takes about 3 minutes. Then the display

shows the outdoor temperature. In case of failure of reception, pls

press"CHANNEL" (C) for more than approx. 3 sec. to receive again.

 The weather station is capable of receiving up to 3 different channels.

Select the channel number (1, 2, or 3) by pressing the "b" switch.

The weather station will scan the 3 channels automatically.

 Select the channel number (1, 2, or 3) by pressing the "CHANNEL"

button (C) on weather station.

 Please observe a minimal distance of 2.5m to sources of interference

such as televisions or computer screens.

MANUAL SET-UP

(The clock automatically changes from set-up mode to time display mode if

no keys are pressed for 20 seconds.)

 Press and hold key "SET" for approx. 2 seconds.

 The display for the year is flashing. Use "UP" and "DOWN" to select the

year.

 Press "SET" to confirm.

 The display for the month is flashing. Use "UP" and "DOWN" to select

the month.

 Press "SET" to confirm.

 The display for the date is flashing. Use "UP" and "DOWN" to select

the date.

 Press "SET" to confirm.

 The language selection for the display of the weekdays is flashing. Use

"UP" and "DOWN" to select the language. (EN for English)

 Press "SET" to confirm.

 The 12/24 hour flashing. Use "UP" and "DOWN" to select

 Press "SET" to confirm.

 The display for the hour is flashing. Use "UP" and "DOWN" to select the

hour.

 Press "SET" to confirm.

 The display for the minutes is flashing. Use "UP" and "DOWN" to select

the minutes.

 Press "SET" to confirm.

Alarm set-up

 Press "ALARM" to switch from time display to AL display

Press and hold the key "ALARM" for approx. 2 seconds ,the flashing

alarm time are shown. The hour display of the alarm time is flashing.

Use "UP" and "DOWN" to select the hour.

 Press "ALARM" to confirm.

Then follow the minutes. Use "UP" and "DOWN" to select the minutes,

 Press "ALARM" to confirm.

Alarm on/off

 When showing AL alarm time, press "SET" to activate the alarm

with alarm symbol showing.

 Press "SET" again cancel the alarm

Snooze function

 Press the key "SNOOZE/LIGHT", while the alarm sounds, to activate

the snooze function. The alarm repeat after 5 minutes.

The snooze function can be stopped by pressing any key.

Max./ Min. for the indoor/outdoor temperature and humidity

 Press "UP" for displaying indoor/outdoor max./min. of temperature

and humidity, hold "UP" for more than approx. 3 seconds to clear up the

max./min.

Temperature alert set-up

As an example this allows to get a frost damage warning. The main unit will

give an alarm signal when the set temperature limit is reached.

 Press and hold the key "DOWN" for approx. 3 sec., ON/OF is flashing

Use "UP" and "DOWN" to select ON/OF.

 Press "SET" , the upper limit temperature is flashing,

Use "UP" and "DOWN" to set the maximum alert temperature.

 Press "SET ", the lower limit temperature is flashing,

Use "UP" and "DOWN" to set the minimum alert temperature.

 Press "SET" to confirm.

When the alert is activated, the alert symbol (

) will be shown.

The set-up process cannot be completed if the maximum temperature

selected is lower than the minimum selected temperature.

The minimum temperature selected must at least be 1°C below the maxi-

mum selected temperature.

Illumination

 Press the key "SNOOZE/LIGHT" to activate the display illumination for

20 seconds.

Comfort index

Comfortable

Dry

Wet

PLEASE NOTE! There is no comfort display when temperature is not in

20-27°C range and humidity is in 40-70% range

WEATHER FORECAST

Sunny

Slightly Sunny

Cloudy

Rainy

The weather station analyzes the weather patterns from the past 24 hours

to determine the forecast for the next 12 – 24 hours. The weather forecast

is only for reference and domestic use. Accuracy rate might be lower in

extreme conditions.

Service hotline

In the case of technical problems, contact our Service hotline. Switzerland:

Tel. 0900 00 1675 (national charges, Swisscom at time of going to print:

CHF 2.60/min). In the case of claims under the terms of guarantee, contact

your sales outlet.

Maintenance

Clean the surface of the housing with a soft, fluff-free cloth. Do not use any

cleaning agents or solvents.

Guarantee

Dexford equipment is produced and tested according to the latest produc-

tion methods. The implementation of carefully chosen materials and highly

developed technologies ensure trouble-free functioning and a long service

life. The terms of guarantee do not apply to the batteries or power packs

used in the products. The period of guarantee is 24 months from the date

of purchase. All deficiencies related to material or manufacturing errors

within the period of guarantee will be redressed free of charge. Rights to

claims under the terms of guarantee are annulled following tampering by

the purchaser or third parties. Damage caused as the result of improper

handling or operation, normal wear and tear, incorrect positioning or

storage, improper connection or installation or Acts of God and other

external influences are excluded from the terms of guarantee. In the case

of complaints, we reserve the right to repair defective parts, replace them

or replace the entire device. Replaced parts or devices become our pro-

perty. Rights to compensation in the case of damage are excluded where

there is no evidence of intent or gross negligence by the manufacturer. If

your device does show signs of a defect within the period of guarantee,

please contact the sales outlet where you purchased the Dexford device,

producing the purchase receipt as evidence. All claims under the terms

of guarantee in accordance with this agreement can only be asserted at

the sales outlet. No claims under the terms of guarantee can be asserted

after a period of two years from the date of purchase and hand-over of the

product.

Disposal

In order to dispose of your device, take it to a collection point

provided by your local public waste authorities (e.g. recycling

centre). According to the laws on the disposal of electronic and

electrical devices, owners are obliged to dispose of old electronic

and electrical devices in a separate waste container. The adjacent

symbol indicates that the device must not be disposed of in normal

domestic waste!

You are legally obliged to dispose of power packs and batteries

at the point of sale or in the corresponding containers provided at

collection points by local public waste authorities. Disposal is free of

charge. The symbols indicate that the batteries must not be disposed of in

normal domestic waste and that they must be brought to collection points

provided by local public waste authorities. Packaging materials must be

disposed of according to local regulations.

Declaration of Conformity

This device fulfils the requirements stipulated in the Directive

1999/5/EC on radio equipment and telecommunications terminal

equipment and the mutual recognition of their conformity. Conformi-

ty with the above mentioned directive is confirmed by the CE mark on the

device. To view the complete Declaration of Conformity, please refer to the

free download available on our web site www.dexford.com.

Feature

Value

WS 2200

W x H x D

80 x 160 x 20 mm

Weight

134 g (without battery)

Signal frequency

433 MHz

Power

2 x 1,5V AAA, not included

Temperature range

0 ~ +50 °C

Humidity range

20 ~ 90 %

Thermo-sensor, max. 30 meters in open area

W x H x D

60 x 95 x 27 mm (including stand)

Weight

55 g (without battery)

Power

2 x 1,5V AAA, not included

Temperature range

-20 ~ +50 °C

To use for indoor and outdoor