Aqua Comfort AC1250 Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schwimmbad-Heizung Aqua Comfort AC1250 herunter. Aqua Comfort AC1250 12 Seiten.
Seite drucken- 1. Table of Contents
- 2. Safety Considerations
- 3. Inspection
- 4. General Information
- 5. Installation
- 6. Water Flow & Connections
- 7. Electrical Connections
- 8. Modes of Operation
- 9. Wiring Diagrams
- 10. Electronic Control Panel
- 11. Chemical Use
- 12. Start-Up
- 13. Maintenance
- 14. Troubleshooting Checklist
- 15. Calling for Service
Because evaporation accounts for about 70 percent of pool heat loss, the beneficial effect of using a pool
cover / solar blanket can be dramatic.
Wind Speed Reduction
Reducing wind velocity at the water surface reduces convective and evaporative losses. Fences,
trees, hills, or tall hedges close to the pool perimeter are effective windbreaks. Locate these obstructions
to take maximum advantage of their effectiveness as windbreaks, without shading the pool surface
from the sun.
MAINTENANCE
WARNING: DISCONNECT ELECTRICAL POWER TO UNIT BEFORE STARTING ANY MAINTENANCE TO
PREVENT SERIOUS INJURY FROM SHOCK.
Protecting your Heater
• Keep your pool filter system clean and free of restrictions to ensure proper water flow.
• Check water chemistry regularly. Misuse of chemicals will cause permanent damage to your heater and
other pool equipment. Manufacturers can void warranties for damage as a result of poor water quality.
• Free airflow is essential. Keep the evaporator coil clean and free of weeds, leaves, glass clippings, dirt
and other debris that will decrease the airflow. Keep fences and shrubs away from air inlets (sides and
back of heater).
• Frequent rinsing of the evaporator with fresh water will remove build up from its surface. Always spray
the coil gently with a regular garden hose being careful not to bend aluminum fins.
• Regular cleaning of the cabinet will improve its appearance and extend the life of the finish.
Winterizing
When the heater is exposed to freezing temperatures, it is essential that all water within the unit be properly
drained. When water freezes it expands, damaging piping.
• Turn thermostat settings to OFF. Turn filter pump to OFF.
• Turn power to unit OFF (i.e. pull disconnect or turn circuit breaker OFF).
• Disconnect water inlet and outlet unions at the back of the unit, be careful not to lose rubber o-rings.
• Flush the heater piping out with fresh water to remove any residual chemicals.
• Use low-pressure air or vacuum to remove water that has accumulated inside the piping of the heater.
10